Mapping Surface Temperatures on a Debris-Covered Glacier With an Unmanned Aerial Vehicle
Open Access
- 30 May 2018
- journal article
- research article
- Published by Frontiers Media SA in Frontiers in Earth Science
- Vol. 6
Abstract
A mantel of debris cover often accumulates across the surface of glaciers in active mountain ranges with exceptionally steep terrain, such as the Andes, Himalaya, and New Zealand Alps. Such a supraglacial debris layer has a major influence on a glacier's surface energy budget, enhancing radiation absorption, and melt when the layer is thin, but insulating the ice when thicker than a few cm. Information on spatially distributed debris surface temperature has the potential to provide insight into the properties of the debris, its effects on the ice below and its influence on the near-surface boundary layer. Here, we deploy an unmanned aerial vehicle (UAV) equipped with a thermal infrared sensor on three separate missions over one day to map changing surface temperatures across the debris-covered Lirung Glacier in the Central Himalaya. We present a methodology to georeference and process the acquired thermal imagery, and correct for emissivity and sensor bias. Derived UAV surface temperatures are compared with distributed simultaneous in situ temperature measurements as well as with Landsat 8 thermal satellite imagery. Results show that the UAV-derived surface temperatures vary greatly both spatially and temporally, with −1.4 ± 1.8, 11.0 ± 5.2, and 15.3 ± 4.7℃ for the three flights (mean ± sd), respectively. The range in surface temperatures over the glacier during the morning is very large with almost 50 °C. Ground-based measurements are generally in agreement with the UAV imagery, but considerable deviations are present that are likely due to differences in measurement technique and approach, and validation is difficult as a result. The difference in spatial and temporal variability captured by the UAV as compared with much coarser satellite imagery is striking and it shows that satellite derived temperature maps should be interpreted with care. We conclude that UAVs provide a suitable means to acquire surface temperature maps of debris-covered glacier surfaces at high spatial and temporal resolution, but that there are caveats with regard to absolute temperature measurement.Keywords
Funding Information
- H2020 European Research Council (676819)
- FP7 Ideas: European Research Council (320816)
- Nederlandse Organisatie voor Wetenschappelijk Onderzoek (016.181.308)
- Department for International Development (PO40082504)
This publication has 59 references indexed in Scilit:
- Review of the status and mass changes of Himalayan-Karakoram glaciersJournal of Glaciology, 2018
- Importance of longwave emissions from adjacent terrain on patterns of tropical glacier melt and recessionJournal of Glaciology, 2017
- A physically based 3‐D model of ice cliff evolution over debris‐covered glaciersJournal of Geophysical Research: Earth Surface, 2016
- Structure from Motion in the Geosciences2016
- A grid-based model of backwasting of supraglacial ice cliffs on debris-covered glaciersAnnals of Glaciology, 2016
- Measuring glacier surface temperatures with ground‐based thermal infrared imagingGeophysical Research Letters, 2015
- High‐resolution modeling of atmospheric dynamics in the Nepalese HimalayaJournal of Geophysical Research: Atmospheres, 2015
- Geographic Object-Based Image Analysis – Towards a new paradigmISPRS Journal of Photogrammetry and Remote Sensing, 2014
- Random ForestsMachine Learning, 2001
- Surface temperature and emissivity at various scales: Definition, measurement and related problemsRemote Sensing Reviews, 1995