Test Methods for the Mechanical Characterization of Flexure Hinges
Open Access
- 8 August 2023
- journal article
- research article
- Published by Springer Nature in Experimental Mechanics
- Vol. 63 (7) , 1203-1222
Abstract
Background: The design of compliant mechanisms requires detailed knowledge about the stiffness properties of their flexible segments. However, there are no standardized test methods for flexure hinges, and therefore the influence of manufacturing-specific effects, such as anisotropy, on the stiffness properties cannot be quantified. Objective: This paper presents novel test methods for variable cross-section flexure hinges subjected to large deformations and pure bending loading, which determine the bending stiffness of flexure hinges over their entire deflection range using a universal testing machine. Methods: The novel test methods for flexure hinges are based on the tensile test, the four-point bending test (FPBT), and the column bending test (CBT). These test methods were initially formulated for constant cross-section specimens, but are adapted in this study to examine variable cross-section specimens. The derived test methods are validated by using isotropic materials with well-known properties and by comparing the calculated deflections with deflections measured by means of image processing. Results: The deflection validation shows that the adapted CBT (aCBT) is accurate over the entire deflection range, achieving curvature of up to $$\kappa =0.40\;\text {mm}^{-1}$$ , whereas the maximum curvature in the adapted FPBT (aFPBT) is limited by the test methodology to about $$\kappa =0.15\;\text {mm}^{-1}$$ . At small strains, the flexural modulus determined in the aCBT and aFPBT agrees well with the Young’s modulus determined in the tensile test, as would be expected for isotropic materials. Conclusion: The aCBT proves to be a suitable test method for flexure hinges at large deflections, whereas the stiffness characterization at small deflections can be performed with both the aCBT and the aFPBT. The presented test methods validated on isotropic materials form the basis for characterizing anisotropic flexure hinges with geometry-dependent stiffness properties.
Keywords
Funding Information
- Deutsche Forschungsgemeinschaft (280656304)
- Technische Universität Braunschweig
This publication has 50 references indexed in Scilit:
- The Portevin–Le Chatelier effect: a review of experimental findingsScience and Technology of Advanced Materials, 2011
- On mechanical properties of planar flexure hinges of compliant mechanismsMechanical Sciences, 2011
- Folding of woven composite structuresComposites Part A: Applied Science and Manufacturing, 2005
- Interpretations of Tensile Properties of Polyamide 6 and PET Based Thermoplastics Using ASTM and ISO Procedures2000
- Elliptical flexure hingesReview of Scientific Instruments, 1997
- Constrained buckling tests show increasing compressive strain to failure with increasing strain gradientComposites Part A: Applied Science and Manufacturing, 1997
- A Method for the Design of Compliant Mechanisms With Small-Length Flexural PivotsJournal of Mechanical Design, 1994
- On the tensile testing of high modulus polymers and the compliance correctionPolymer Engineering & Science, 1993
- Comparison between flexural and tensile modulus of fibre compositesFibre Science and Technology, 1984
- Frictional Effects in Four-Point BendingA S L E Transactions, 1975