Temperature‐Induced Gelation of Concentrated Sialon Suspensions
- 2 March 2005
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 88 (3) , 593-598
Abstract
A temperature‐induced gelation method has been developed for the preparation of sialon green bodies composed of Si3N4, AlN, Y2O3, and Al2O3. Using a polyester/polyamine condensation polymer as dispersant, stable suspension containing sialon, precursor powders could be prepared in methyl ethyl keton (MEK)/ethanol (E) solvent mixture with solids loading as high as 60 vol%. The solvency of the dispersant in MEK/E decreased dramatically on cooling. The sedimentation tests showed that the settling behavior changed from slow accumulation at ∼20°C to fast deposition of clusters at −15°C, because of the collapse of dispersant chains adsorbed at the surface of the particles. Steady shear viscosity and oscillatory measurements performed for 60 vol% suspensions as functions of temperature and added amounts of dispersant proved that suspensions were of low viscosity and high stability at room temperature, becoming predominantly very highly viscous and elastic as temperature decreased. The gelation mechanism was mainly based on the coiling up of dissolved dispersant molecules, inducing in situ gelation and the formation of a rigid network bridging the suspended particles. The green bodies showed negligible shrinkage during gelation, a small shrinkage during drying, homogeneous microstructures, narrow pore size distributions, and high relative density. It was possible to achieve dense α‐sialon ceramics through pressureless sintering at 1750°C for 2 h.Keywords
This publication has 22 references indexed in Scilit:
- Thermoreversible Gelcasting: A Novel Ceramic Processing TechniqueJournal of the American Ceramic Society, 2002
- Coagulation Method of Aqueous Concentrated Alumina Suspensions by Thermal Decomposition of Hydroxyaluminum DiacetateJournal of the American Ceramic Society, 2000
- Novel Powder‐Processing Methods for Advanced CeramicsJournal of the American Ceramic Society, 2000
- Gelcasting Automation for High Volume Production of Silicon Nitride Turbine Wheels1999
- Influence of Powder Properties and Green Microstructure on the Sintering Behavior of Si3N4Journal of the Ceramic Society of Japan, 1993
- Gelcasting of AluminaJournal of the American Ceramic Society, 1991
- Applicability of Quicksettm Injection Molding to Intelligent Processing of Ceramics1991
- Better Sintering through Green‐State Deformation ProcessingJournal of the American Ceramic Society, 1990
- Powder Processing Science and Technology for Increased ReliabilityJournal of the American Ceramic Society, 1989
- Liquid Redistribution during Liquid‐Phase SinteringJournal of the American Ceramic Society, 1986