Influence of laser surface texturing on surface microstructure and mechanical properties of adhesive joined steel sheets
Authors:
- F. Y. SakataFSF. Y. Sakata
- A. M. E. SantoASA. M. E. Santo
- W. MiyakawaWMW. Miyakawa
- R. RivaRRR. Riva
- M. S. F. LimaM. S. F. Lima
- 1 April 2009
- journal article
- Published by SAGE Publications in Surface Engineering
- Vol. 25 (3) , 180-186
Abstract
This work discusses the resultant microstructure of laser surface treated galvanised steel and the mechanical properties of adhesively bonded surfaces therein. The surface microstructure obtained at laser intensities between 170 and 1700 MW cm−2 exhibit zinc melting and cavity formation. The wavy surface morphology of the treated surface exhibits an average roughness Ra between 1·0 and 1·5 μm, and a mean roughness depth Rz of 8·6 μm. Atomic force microscopic analyses revealed that the Rz inside the laser shot cavities increased from 68 to 243 nm when the incident laser intensity was increased from 170 to 1700 MW cm−2. X-ray fluorescence analyses were used to measure Zn coating thicknesses as a function of process parameters. Both X-ray fluorescence and X-ray diffraction analyses demonstrated that the protective coating remains at the material surface, and the steel structure beneath was not affected by the laser treatment. Tensile tests under peel strength conditions demonstrated that the laser treated adhesively joined samples had resistance strength up to 88 MPa, compared to a maximum of only 23 MPa for the untreated surfaces. The maximum deformation for rupture was also greatly increased from 0·07%, for the original surface, to 0·90% for the laser treated surfaces.Keywords
This publication has 9 references indexed in Scilit:
- Adhesive Bonding of Aluminum AlloysMetal Finishing, 2007
- Efficiency of the laser texturing on the adhesion of the coated twist drillsJournal of Materials Processing Technology, 2006
- Determination of layer thickness with μXRFApplied Surface Science, 2005
- Thermal non-linear stresses in an adhesively bonded and laser-spot welded single-lap joint during laser–metal interactionJournal of Materials Processing Technology, 2003
- Adhesive bonding of aircraft structuresInternational Journal of Adhesion and Adhesives, 2000
- Excimer laser surface modification of coated steel for enhancement of adhesive bondingApplied Surface Science, 1998
- Improvement of adhesive bonding in aluminium alloys using a laser surface texturing processJournal of Materials Processing Technology, 1997
- Comments on explosive mechanisms of laser sputteringApplied Surface Science, 1996
- X-ray Fluorescence Analysis of Alloy-electroplated Coatings on Steel with K and L Series EmissionsTransactions of the Iron and Steel Institute of Japan, 1988