Classification and Identification of Overlap and Gap Regions in Path-Planning for Automated Fiber Placement Technology
Open Access
- 8 October 2026
- journal article
- research article
- Published by MDPI AG in Journal of Composites Science
- Vol. 10 (10) , 530
Abstract
Automated Fiber Placement (AFP) of carbon-fiber composite materials constitutes a core digital manufacturing technology for large-scale aerospace composite components with double-curved surfaces. Gap and overlap defects induced during path planning degrade the fatigue performance of composite parts and threaten aircraft structural safety. Aiming at the limitation that conventional post-forming non-destructive testing cannot predict lay-up defects at the design stage, this work analyzes the generation mechanisms of gaps and overlaps from differential-geometric constraints of non-developable surfaces. A defect classification framework and geometric identification method oriented to the path-planning phase are established. According to geometric formation causes, lay-up defects are categorized into boundary overlap–gaps induced by tow-cutting operations and internal gaps originating from trajectory divergence over curved surfaces. Twenty boundary working conditions are defined for triangular boundary defects, and internal gaps are further subdivided into tape-type gaps and rectangular gaps. A triangular-patch approximation algorithm is adopted to compute the area of gap–overlap regions and quantitatively evaluate lay-up coverage. The simulation results reveal an inherent trade-off between allowable fiber-angle deviation and lay-up coverage on double-curved mold surfaces.Keywords
This publication has 33 references indexed in Scilit:
- Ply Surface Modeling and Path Planning for Automated Fiber Placement of Complex Composite Structures With Large and Variable ThicknessPolymer Composites, 2025
- Lay‐up defects inspection for automated fiber placement with structural light scanning and deep learningPolymer Composites, 2025
- Optimisation of a composite pressure vessel dome using non-geodesic tow paths and automated fibre placement manufacturingComposites Part B: Engineering, 2024
- Predicting gaps and overlaps in Automated Fiber Placement composites by measuring sources of manufacturing process variationsComposites Part B: Engineering, 2024
- Modelling the effect of process conditions on steering-induced defects in automated fibre placement (AFP)Composites Part A: Applied Science and Manufacturing, 2023
- Effects of tow-to-tow gaps in composite laminates fabricated via automated fiber placementComposites Part A: Applied Science and Manufacturing, 2018
- An experimental and simulative study on the defects appeared during tow steering in automated fiber placementComposites Part A: Applied Science and Manufacturing, 2018
- Influence of embedded gap and overlap fiber placement defects on the microstructure and shear and compression properties of carbon–epoxy laminatesComposites Part A: Applied Science and Manufacturing, 2016
- Defect layer method to capture effect of gaps and overlaps in variable stiffness laminates made by Automated Fiber PlacementComposite Structures, 2013
- Generating realistic laminate fiber angle distributions for optimal variable stiffness laminatesComposites Part B: Engineering, 2012