Inhomogeneity of microstructure and mechanical properties in compression-type bulk formed specimens
- 18 November 2022
- journal article
- research article
- Published by SAGE Publications in Proceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture
- Vol. 237 (10) , 1485-1496
Abstract
The effect of elongation and spreading in a material on strain and microstructure inhomogeneity during compression-type bulk forming processes was investigated to improve the strain homogeneity of the materials. For systematic investigation, four different compression-type forming processes, namely wire flat rolling, plate flat rolling, wire caliber rolling, and uniaxial compression, were compared. Strain inhomogeneity and macroscopic shear bands (MSBs) were clearly observed during the compression-type bulk forming processes based on a comparative study on the shape change, effective strain and hardness distributions, and microstructural evolution in twinning-induced plasticity steel. The flat-rolled wire had the largest strain inhomogeneity, followed by the caliber-rolled wire, compressed specimen, and flat-rolled plate in the listed order. The inhomogeneity of the strain distribution along the horizontal direction tended to increase with the pure spreading during the forming process. Meanwhile, the inhomogeneity of the strain distribution along the vertical direction increased with decreasing elongation during the process. Therefore, a small pure spreading and large elongation of the specimen result in more homogeneous and higher quality products in the compression-type bulk forming process. For instance, the flat-rolled plate exhibited weak MSBs and low strain inhomogeneity because of the small pure spreading and large elongation during the forming process.Keywords
This publication has 31 references indexed in Scilit:
- Caliber-rolled TWIP steel for high-strength wire rods with enhanced hydrogen-delayed fracture resistanceScripta Materialia, 2012
- Deformation inhomogeneity in roll drawing processJournal of Manufacturing Processes, 2012
- Predictive modeling of grain refinement during multi-pass cold rollingJournal of Materials Processing Technology, 2012
- Orientation dependence of shear banding in face-centered-cubic single crystalsActa Materialia, 2012
- Influence of addition elements on the stacking-fault energy and mechanical properties of an austenitic Fe–Mn–C steelMaterials Science and Engineering: A, 2008
- A neural network-assisted finite element analysis of cold flat rollingEngineering Applications of Artificial Intelligence, 2008
- Strain distribution and microstructural evolution in multi-pass warm caliber rollingMaterials Science and Engineering: A, 2007
- The prediction of macroscopic shear bands in flat rolled wire using the finite and slab element methodMaterials Letters, 2006
- Cold Rolling of FoilProceedings of the Institution of Mechanical Engineers, Part B: Journal of Engineering Manufacture, 1992
- The occurrence of shear bands in isothermal, hot forgingMetallurgical Transactions A, 1982