The Effect of Modification of an Epoxy Resin Adhesive with ATBN on Peel Strength
Authors:
- 1 February 1992
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 37 (1-3) , 15-31
Abstract
The effects of rubber content, rate of peel and temperature on peel strength of ATBN modified DGEBA based epoxy resin adhesives have been investigated. The fracture surfaces of peel test specimens and the distribution of rubber particles in cured bulk epoxy resin have been observed with SEM and TEM, respectively. The mechanical properties of bulk rubber modified epoxy resin have been also measured. The peel strengths increased with increasing rubber content, peel rate, and decreasing temperature. The peel strengths were superposed as a function of rate and temperature. Plots of the shift factors against temperature gave two straight lines, which followed an Arrhenius relationship. The region of temperature below the intersection of the two straight lines, temperature somewhat lower than Tg of epoxy adhesive, gave markedly high peel strengths and a stick-slip failure due to plastic deformation of the adhesive, and a number of micro holes produced by the rupture of rubber micro particles on the fracture surface. The region of temperature above the intersection gave lower peel strengths and an apparent interfacial failure with ductile fracture of the adhesive, and larger, shallow holes or no holes. From these results, the marked increase of peel strength was concluded to be mainly attributed to the plastic or viscoelastic deformation of epoxy matrix, the strong bond at the interface between rubber particles and epoxy matrix, and the dilation and rupture of a number of rubber particles.Keywords
This publication has 20 references indexed in Scilit:
- Morphology and mechanical properties of amine‐terminated butadiene‐acrylonitrile/epoxy blendsPolymer Engineering & Science, 1986
- Dynamic mechanical properties and adhesive strengths of epoxy resins modified with liquid rubber. I. Modification with ATBNJournal of Applied Polymer Science, 1985
- Influence of the temperature of cure on the mechanical properties of ATBN/epoxy blendsPolymer, 1985
- Viscoelastic fracture behaviour for different rubber-modified epoxy adhesive formulationsInternational Journal of Adhesion and Adhesives, 1985
- Deformation and fracture behaviour of a rubber-toughened epoxy: 1. Microstructure and fracture studiesPolymer, 1983
- Morphology and toughness characterization of epoxy resins modified with amine and carboxyl terminated rubbersPolymer, 1982
- Viscoelastic Fracture of Structural AdhesivesThe Journal of Adhesion, 1981
- Characterization of the phase structure of an amine cured rubber modified epoxyPolymer, 1981
- A model for the toughness of epoxy-rubber particulate compositesJournal of Materials Science, 1980
- Dynamic mechanical properties of epoxy–rubber polyblendsJournal of Applied Polymer Science, 1973