Electrodeposition of ZnMn Alloys Using Pulse Plating
- 1 January 2003
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 150 (11) , C772-C776
Abstract
Zinc-manganese alloys were electrodeposited from a citrate-ethylenediaminetetraacetic acid electrolyte using pulse plating. The influence of the pulse parameters (current density, duty cycle, and pulse frequency) on the alloys’ properties and current efficiency was analyzed. By correctly selecting these parameters, pulse plating improved some coatings’ properties, mainly their morphology and structure. Results indicated that at high current densities, where a mixture of phases was always obtained using direct current, pulse plating enabled pure manganese to dissolve during off-time, and this allowed us to obtain monophasic alloys with a high manganese content. © 2003 The Electrochemical Society. All rights reserved.Keywords
This publication has 13 references indexed in Scilit:
- Electrodeposition of Zn–Mn alloys in the presence of thiocarbamideSurface and Coatings Technology, 2002
- Electrodeposition of Zn-Mn Alloys at Low Current DensitiesJournal of the Electrochemical Society, 2002
- Pulse-plating of copper–cobalt alloysElectrochimica Acta, 1999
- Electrodeposition and plastic behavior of low-manganese zinc-manganese alloy coatings for automotive applicationsMetal Finishing, 1999
- Experience with a pilot plant for the electrodeposition of Zn-Mn on wireTransactions of the IMF, 1998
- Zn-Mn Alloy Electrodeposition on SteelTransactions of the IMF, 1997
- A surface coverage model for pulse-plating of binary alloys exhibiting a displacement reactionElectrochimica Acta, 1997
- Zinc Manganese Alloy ElectrodepositionTransactions of the IMF, 1996
- Effect of Off‐Time on the Composition of Pulse‐Plated Cu‐Ni AlloysJournal of the Electrochemical Society, 1995
- Effect of Corrosion on the Composition of Pulse‐Plated Cu‐Ni AlloysJournal of the Electrochemical Society, 1994