Effect of Cooling Rates on the Second‐Phase Precipitation and Proeutectoid Phase Transformation of a Nb–Ti Microalloyed Steel Slab
Authors:
- 30 October 2012
- journal article
- research article
- Published by Wiley in Steel Research International
- Vol. 84 (4) , 370-376
Abstract
During the continuous casting of low‐carbon Nb–Ti microalloyed steel, control of the slab surface microstructure and the behavior of the second‐phase precipitation are significantly influenced by the cooling rate. Through confocal laser scanning microscopy, the effect of the cooling rate on the behavior of ferrite precipitation both at the grain boundary and within the austenite was observed in situ and analyzed. The relationship between the cooling rate and precipitation of the microalloying elements on the slab surface microstructure was further analyzed by transmission electron microscopy. The results showed that the effect of microalloying element precipitation on proeutectoid ferrite phase transformation is mainly manifested in two aspects: (i) the carbonitrides of microalloying elements act as inoculant particles to promote nucleation of the proeutectoid ferrite and (ii) the carbon near the grain boundary is depleted when the microalloying elements precipitate into carbonitrides, inducing a decrease in the local carbon concentration and promoting ferrite precipitation.Keywords
This publication has 8 references indexed in Scilit:
- Effect of Cooling Patterns on Microstructure and Mechanical Properties of Hot-Rolled Nb Microalloyed Multiphase Steel PlatesJournal of Iron and Steel Research International, 2011
- Carbide precipitation kinetics in austenite of a Nb–Ti–V microalloyed steelMaterials Science and Engineering: A, 2011
- Dissolution and Precipitation Kinetics of Nb(C,N) in Austenite of a Low-Carbon Nb-Microalloyed SteelMetallurgical and Materials Transactions A, 2009
- Effect of TiN Precipitates on Austenite Grain Size in Fe–1.5%Mn–0.12%Ti–Si(<1.1%)–C(0.05 and 0.15%) AlloyISIJ International, 2008
- Prevention of slab surface transverse cracking at Kashima n° 2 caster with Surface Structure Control (SSC) coolingRevue de Métallurgie, 2006
- Prevention of Slab Surface Transverse Cracking by Microstructure ControlISIJ International, 2003
- Compression Test to Reveal Surface Crack Sensitivity between 700 and 1100.DEG.C. of Nb-bearing and High Ni Continuous Casting Slabs.ISIJ International, 2002
- A new theory and kinetic modeling of strain-induced precipitation of Nb(CN) in microalloyed austeniteMetallurgical and Materials Transactions A, 1995