Microstructure and Properties of a Hot Rolled-Quenched Cu-Cr-Zr-Mg-Si Alloy
- 6 December 2011
- journal article
- Published by Springer Nature in Journal of Materials Engineering and Performance
- Vol. 21 (8) , 1800-1805
Abstract
No abstract availableKeywords
This publication has 16 references indexed in Scilit:
- Microstructure and Properties of Cu-Cr Alloys Prepared by a Shortened Process and a Conventional ProcessAdvanced Materials Research, 2011
- Characterization of the mechanical properties changes in an Al–Zn–Mg alloy after a two-step ageing treatment at 70° and 135°CMaterials & Design (1980-2015), 2010
- Microstructure and properties of high-conductivity, super-high-strength Cu–8.0Ni–1.8Si–0.6Sn–0.15Mg alloyJournal of Materials Research, 2009
- Mechanical properties of Cu–Cr system alloys with and without Zr and AgJournal of Materials Science, 2007
- Prediction and Analysis of the Aging Properties of Rapidly Solidified Cu-Cr-Sn-Zn Alloy Through Neural NetworkJournal of Materials Engineering and Performance, 2005
- Influence of Thermomechanical Processing on the Microstructure and Properties of a Cu-Cr-P AlloyJournal of Materials Engineering and Performance, 2002
- Microstructure and properties of a Cu–Cr–Zr alloyJournal of Nuclear Materials, 2001
- Control of Microstructures and Properties of a Phosphorus-Containing Cu-0.6 Wt.% Cr Alloy through Precipitation TreatmentJournal of Materials Engineering and Performance, 2000
- Crystallography and morphology of nanosized Cr particles in a Cu–0.2% Cr alloyActa Materialia, 2000
- Correlation between the electrical conductivity and aging treatment for a Cu-15 wt% Cr alloy composite formed in-situMaterials Letters, 1997