Multi-objective optimization of the coat-hanger die for melt-blowing process
Authors:
- 1 May 2012
- journal article
- Published by Springer Nature in Fibers and Polymers
- Vol. 13 (5) , 626-631
Abstract
No abstract availableKeywords
This publication has 24 references indexed in Scilit:
- Optimal design of the coat‐hanger die used for producing melt‐blown fabrics by finite element method and evolution strategiesPolymer Engineering & Science, 2008
- Numerical computation of the fiber diameter of melt blown nonwovens produced by the inset dieJournal of Applied Polymer Science, 2008
- Numerical analysis of the stagnation phenomenon in the coat‐hanger die of melt blowing processJournal of Applied Polymer Science, 2008
- Simulation of the polymeric fluid flow in the feed distributor of melt blowing processJournal of Applied Polymer Science, 2006
- Effects of Processing Parameters on the Fiber Diameter of Melt Blown Nonwoven FabricsTextile Research Journal, 2005
- Modeling the Air-Jet Flow Field of a Dual Slot Die in the Melt Blowing Nonwoven ProcessTextile Research Journal, 2004
- Three-Dimensional Model of the Melt-Blowing ProcessIndustrial & Engineering Chemistry Research, 2003
- Design of coat‐hanger sheeting dies based on ratio of residence times in manifold and slotPolymer Engineering & Science, 1980
- Residence time distribution of polymer melt in the T‐diePolymer Engineering & Science, 1980
- Geometry design of a coat‐hanger die with uniform flow rate and residence time across the die widthPolymer Engineering & Science, 1979