THE DEVELOPMENT OF A MANDREL PEEL TEST FOR THE MEASUREMENT OF ADHESIVE FRACTURE TOUGHNESS OF EPOXY–METAL LAMINATES
Authors:
- 1 March 2004
- journal article
- research article
- Published by Taylor & Francis in The Journal of Adhesion
- Vol. 80 (3) , 147-167
Abstract
A mandrel peel test is established for measuring the adhesive fracture toughness of a metal/rubber-toughened epoxy laminate system. By adopting an energy balance analysis it is possible to determine directly both adhesive fracture toughness and plastic work in bending the peel arm around the mandrel. The suitability of the procedure is examined for various types of metal peel arms, which are classified in terms of their ability to deform plastically during the test. The plastic work is also predicted theoretically, and comparisons are made between the measured and calculated values. The fracture energies determined from the mandrel tests are compared with those obtained from 90° fixed-arm peel tests. For the calculations of plastic work in bending in the fixed arm test, various options are used when modelling the tensile stress-strain behaviour of the peel arm material. In addition, the adhesive layer thickness is considered in terms of its influence on the calculation of adhesive fracture toughness.Keywords
This publication has 5 references indexed in Scilit:
- Cohesive zone models and the plastically deforming peel testThe Journal of Adhesion, 2003
- The Determination of Adhesive Fracture Toughness for Laminates by the use of Different Test Geometry and Consideration of Plastic Energy Correction Factors2003
- Experimental determination of the peel adhesion strength for metallic foilsJournal of Adhesion Science and Technology, 1998
- The peeling of flexible laminatesInternational Journal of Fracture, 1994
- Effect of Peel Angle Upon Peel ForceThe Journal of Adhesion, 1987