Development of Adaptive Seat Mounts for Helicopter Aircrew Body Vibration Reduction
Authors:
- 7 May 2009
- journal article
- Published by SAGE Publications in Journal of Vibration and Control
- Vol. 15 (12) , 1809-1825
Abstract
Helicopter aircrew are exposed to high levels of vibration and noise during flight. This paper presents the investigation of adaptive seat mount approaches to reducing vibration on the helicopter seat. A flight test on a helicopter with typical pilot configurations showed that the vibration spectra on the pilot’s helmet not only included the dominant N/rev harmonic peaks of the rotor speed, but also consisted of a low-frequency resonant peak in the frequency range of human abdominal and spine resonant frequencies. Long-term exposure to this vibration may lead to occupational health issues such as damage to the pilot’s spine and neck. In order to address this issue, a novel adaptive seat mount concept was developed to mitigate the vibration levels transmitted to the aircrew. As a proof-of-concept demonstration, a miniature modal shaker was installed between the cabin floor and the seat bottom as an adaptive mount that provided the actuation authority. The objective was to reduce the vertical vibration transmitted to the aircrew helmet in order to decrease aircrew neck and spine injuries that are caused by the transmitted vibration. Extensive closed-loop control tests have been conducted on a full-scale helicopter seat and a mannequin with varying physical properties. A 10,000 lb(f) mechanical shaker was used to provide representative helicopter vibration profiles to the seat. Significant vibration reductions on the N/rev vibration peaks were achieved1 the low-frequency resonant peak was also suppressed simultaneously.Keywords
This publication has 10 references indexed in Scilit:
- Smart Spring Impedance Control Algorithm for Helicopter Blade Harmonic Vibration SuppressionJournal of Vibration and Control, 2005
- An investigation of a semiactive suspension for a fork lift truckVehicle System Dynamics, 2005
- A Two-Stage Vibration Isolation System Featuring an Electrorheological Damper via the Semi-Active Static Output Feedback Variable Structure Control MethodJournal of Vibration and Control, 2004
- Development of a piezoelectric actuator for trailing edge flap control of full scale rotor bladesSmart Materials and Structures, 2001
- The relationship between positive position feedback and output feedback controllersSmart Materials and Structures, 1999
- ACTIVE ISOLATION OF MULTIPLE STRUCTURAL WAVES ON A HELICOPTER GEARBOX SUPPORT STRUTJournal of Sound and Vibration, 1997
- Wind Tunnel Test of a Smart Rotor Model with Individual Blade Twist ControlJournal of Intelligent Material Systems and Structures, 1997
- A control theory approach to the stability and transient analysis of the filtered-x LMS adaptive notch filterIEEE Transactions on Signal Processing, 1992
- Use of random noise for on-line transducer modeling in an adaptive active attenuation systemThe Journal of the Acoustical Society of America, 1989
- Adaptive noise canceling applied to sinusoidal interferencesIEEE Transactions on Acoustics, Speech, and Signal Processing, 1977