The Influence of Ethanol Blends on Particulate Matter Emissions from Gasoline Direct Injection Engines
Authors:
- 12 April 2010
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Particulate Matter (PM) legislation for gasoline engines and the introduction of gasoline/ethanol blends, make it important to know the effect of fuel composition on PM emissions. Tests have been conducted with fuels of known composition in both a single-cylinder engine and V8 engine with a three-way catalyst. The V8 engine used an unleaded gasoline (PURA) with known composition and distillation characteristics as a base fuel and with 10% by volume ethanol. The single-cylinder engine used a 65% iso-octane - 35% toluene mixture as its base fuel. The engines had essentially the same combustion system, with a centrally mounted 6-hole spray-guided direct injection system. Particle size distributions were recorded and these have also been converted to mass distributions. Filter samples were taken for thermo-gravimetric analysis (TGA) to give composition information.Both engines were operated at 1500 rpm under part load. The tests with the single-cylinder engine used lambda of 0.9, 1.0 and 1.1 with an ignition timing sweep of 15-45° bTDC. The trends with the stoichiometric and weak mixtures were less clear (the PM emissions being at low levels), but with lambda of 0.9 the trends were clear. For the rich mixture, advancing the ignition timing increased both PM number and mass emissions, and the use of E10 reduced the number emissions by a factor of 25-65 and the mass emissions by a factor of 2-10.The V8 tests were at stoichiometric with injection timing sweeps during induction (120 to 360° bTDC), with a reduction in both PM number and mass due to reactions in the catalyst. The earlier injection gave lower PM emissions and this was attributed to there being more time for mixture preparation, leading to a more homogeneous mixture. The addition of 10% ethanol led to an increase in PM emissions (both in terms of mass and number).Keywords
This publication has 9 references indexed in Scilit:
- Effect of ethanol–diesel blend fuels on emission and particle size distribution in a common-rail direct injection diesel engine with warm-up catalytic converterRenewable Energy, 2008
- Characteristics of Ethanol, Butanol, Iso-Octane and Gasoline Sprays and Combustion from a Multi-Hole Injector in a DISI EngineSAE International Journal of Fuels and Lubricants, 2008
- Emissions from light duty gasoline vehicles operating on low blend ethanol gasoline and E85Atmospheric Environment, 2008
- Particulate and Hydrocarbon Emissions from a Spray Guided Direct Injection Spark Ignition Engine with Oxygenate Fuel BlendsSAE International Journal of Advances and Current Practices in Mobility, 2007
- The effective density and fractal dimension of particles emitted from a light-duty diesel vehicle with a diesel oxidation catalystJournal of Aerosol Science, 2007
- Particulate Matter and Hydrocarbon Emissions Measurements: Comparing First and Second Generation DISI with PFI in Single Cylinder Optical EnginesSAE International Journal of Advances and Current Practices in Mobility, 2006
- Engine performance and pollutant emission of an SI engine using ethanol–gasoline blended fuelsAtmospheric Environment, 2002
- Regulated and unregulated emissions from an internal combustion engine operating on ethanol-containing fuelsAtmospheric Environment, 2001
- Effects of oxygenated blending compounds on emissions from a turbocharged direct injection diesel engineInternational Journal of Engine Research, 2000