High-voltage solar-cell chip
Authors:
- 15 February 1985
- journal article
- research article
- Published by AIP Publishing in Journal of Applied Physics
- Vol. 57 (4) , 1343-1346
Abstract
Integrated circuit technology has been successfully applied to the design and fabrication of 0.5×0.5‐cm planar multijunction solar‐cell chips. Each of these solar cells consisted of six voltage‐generating unit cells monolithically connected in series and fabricated on a 75‐μm‐thick, p‐type, single crystal, silicon substrate. A contact photolithic process employing five photomask levels together with a standard microelectronics batch‐processing technique were used to construct the solar‐cell chip. The open‐circuit voltage increased rapidly with increasing illumination up to 5 AM1 suns where it began to saturate at the sum of the individual unit‐cell voltages at a maximum of 3.0 V. A short‐circuit current density per unit cell of 240 mA/cm2 was observed at 10 AM1 suns.Keywords
This publication has 6 references indexed in Scilit:
- Planar multijunction high voltage solar cell chipJournal of Applied Physics, 1982
- The contoured-oxide monolithic series-array solar batteryJournal of Applied Physics, 1981
- A one-dimensional theory of high base resistivity tandem-junction solar cells in low injectionIEEE Transactions on Electron Devices, 1980
- Monolithic solar cell panel of amorphous siliconSolar Energy, 1979
- The V-groove multijunction solar cellIEEE Transactions on Electron Devices, 1979
- Oxidation induced stacking faults in n- and p-type (100) siliconJournal of Applied Physics, 1977