Local Measurements in Heat Exchangers: A Systematic Review and Regression Analysis
- 6 December 2021
- journal article
- review article
- Published by Taylor & Francis in Heat Transfer Engineering
- Vol. 43 (18) , 1529-1565
Abstract
It is widely known that most of the heat transfer and pressure drop measurements in heat exchangers are global measurements that are based on surface averaged parameters that do not measure the growth of the hydraulic and thermal boundary layer. Recent local heat transfer coefficient investigations on hydrocarbon condensation in plate heat exchangers suggest that the mean heat transfer coefficients obtained from local measurements are 10-20% higher than those obtained from studies based on a uniform wall heat flux assumption. Consequently, process heat exchangers which were rated by global measurements could be underrated. This systematic review presents a meta-analysis and regression analysis of the available pressure drop and heat transfer data for both single-phase and two-phase flows in enhanced heat exchangers. Data was compiled from studies in the last decade for similar Reynolds, Prandtl, Dean, Weber, and boiling numbers, pitch/diameter ratio, and other parameter ratios for statistical analysis and correlation development. State-of-the-art local measurement techniques like liquid crystal thermography are also discussed. Both practicing engineers and graduate students should benefit from this study.Keywords
This publication has 105 references indexed in Scilit:
- Detailed measurements of heat transfer coefficients in a 180-deg rectangular turned channel with the perforation dividerInternational Journal of Heat and Mass Transfer, 2011
- Thermo-chemical characteristics of R134a flow boiling in helically coiled tubes at low mass flux and low pressureThermochimica Acta, 2011
- Local convective boiling heat transfer and pressure drop of nanofluid in narrow rectangular channelsApplied Thermal Engineering, 2010
- Investigation of local heat transfer coefficients in plate heat exchangers with temperature oscillation IR thermography and CFDInternational Journal of Heat and Mass Transfer, 2010
- Coriolis and rotating buoyancy effect on detailed heat transfer distributions in a two-pass square channel roughened by 45° ribs at high rotation numbersInternational Journal of Heat and Mass Transfer, 2010
- Probabilistic flow pattern-based heat transfer correlation for condensing intermittent flow of refrigerants in smooth horizontal tubesInternational Journal of Heat and Mass Transfer, 2010
- An evaluation of prediction methods for saturated flow boiling heat transfer in mini-channelsInternational Journal of Heat and Mass Transfer, 2009
- Advanced micro-fin tubes for condensationInternational Journal of Heat and Mass Transfer, 1996
- Saturated flow boiling of water in vertical tubesInternational Journal of Heat and Mass Transfer, 1989
- Study on forced convective heat transfer in curved pipesInternational Journal of Heat and Mass Transfer, 1967