Investigation of Surface Segregation in Fe-Cr-Si Alloys by XPS
Open Access
- 19 April 2020
- journal article
- research article
- Published by Springer Nature in Metallurgical and Materials Transactions A
- Vol. 51 (6) , 3076-3089
Abstract
The surface segregation of Fe-Cr-Si alloys was studied using the X-ray photoelectron spectroscopy (XPS). The experiment was performed in two stages, for the as-prepared samples and after oxidation process. Analysis of measured XPS spectra allowed one to characterize the changes in the surface chemical composition during the oxidation and thermal treatment procedures. According to the obtained results, it could be stated that the enhanced anti-corrosion properties of the Fe-Cr-Si alloys which contain more than 10 at. pct of Cr and 5 at. pct of Si in the bulk are mainly connected with the strong surface segregation process of both solutes. In the case of alloys which contain less solutes (Fe0.94Cr0.03Si0.03, Fe0.90Cr0.05Si0.05), the behavior of Cr atoms is different during the oxidation process. Chromium does not segregate to the surface, instead it diffuses into deeper parts of the material leaving the surface covered only by silicon and iron oxides. This effect is responsible for much worse corrosion resistance of the Fe0.94Cr0.03Si0.03 and Fe0.90Cr0.05Si0.05 alloys.Keywords
This publication has 29 references indexed in Scilit:
- Comparison of the Oxidation Process in Pure Iron and Diluted Fe–Si Alloys: A Transmission Mössbauer Spectroscopy StudyOxidation of Metals, 2016
- An investigation of the corrosion of polycrystalline iron by XPS, TMS and CEMSPhysica B: Condensed Matter, 2016
- Oxidation and surface segregation of chromium in Fe–Cr alloys studied by Mössbauer and X-ray photoelectron spectroscopyJournal of Nuclear Materials, 2014
- Surface parameters of ferritic iron-rich Fe–Cr alloyJournal of Physics: Condensed Matter, 2013
- Segregation of Cr impurities at bcc iron surfaces: First-principles calculationsPhysical Review B, 2008
- Surface segregation in FeSi alloysSurface Science, 2006
- Introduction to the High Temperature Oxidation of Metals2006
- Surface Modification of Various Fe–si and Fe–mn Alloys by Oxidation/Reduction TreatmentsSurface Engineering, 2004
- Competitive surface segregation of C, Al and S impurities in Fe(100)Journal of Physics: Condensed Matter, 2003
- Effect of the surface segregation of chromium on oxidation of high-purity FeCr alloys at room temperatureApplied Surface Science, 1996