High-temperature proton exchange membrane fuel cell – Approaches to better performances
Open Access
- 1 January 2023
- conference paper
- Published by AIP Publishing in AIP Conference Proceedings
- Vol. 2689 (1)
Abstract
The methods to improve the performances of a High-Temperature Proton Exchange Membrane Fuel Cell (HT-PEMFC) have been studied. Two approaches were tested: the catalyst layer (CL) combination and external temperature control. The CL structures, properties, binder, and platinum/carbon (Pt/C) concentration were chosen as perimeters to find the best CL combination. The lowest weight percentage of Pt/C, provides the thickest CL with a smaller size and uniform distribution of Pt catalyst. Consequently, the electrochemical reaction can easily happen. The Polytetrafluoroethylene (PTFE) binder provides a higher gas permeability, resulting in more gases diffusing to the working area. The maximum current density of 0.62 A/cm2 and the highest power density of 190.15 mW/cm2 at 0.3067 V was reached, and the best combination of CL is 10 wt% Pt/C with PTFE binder. Temperature control of HT-PEMFC stack with heat pipe (HP) is also successfully proved. Both heating and cooling by HP provide a more uniform temperature distribution in the working area and a low-temperature gradient across the stack than the commonly used technique for controlling fuel cell temperature.Keywords
This publication has 13 references indexed in Scilit:
- A review of high-temperature proton exchange membrane fuel cell (HT-PEMFC) systemInternational Journal of Hydrogen Energy, 2017
- A comprehensive review of PBI-based high temperature PEM fuel cellsInternational Journal of Hydrogen Energy, 2016
- Determination of the optimal operating temperature range for high temperature PEM fuel cell considering its performance, CO tolerance and degradationEnergy Conversion and Management, 2015
- Durability study of HTPEMFC through current distribution measurements and the application of a modelInternational Journal of Hydrogen Energy, 2014
- Effect of Polytetrafluoroethylene (PTFE) and micro porous layer (MPL) on thermal conductivity of fuel cell gas diffusion layers: Modeling and experimentsJournal of Power Sources, 2014
- PTFE Distribution in High-Temperature PEM Electrodes and Its Effect on the Cell PerformanceECS Transactions, 2013
- Validation of an externally oil-cooled 1 kWel HT-PEMFC stack operating at various experimental conditionsInternational Journal of Hydrogen Energy, 2013
- Membrane electrode assemblies doped with H3PO4 for high temperature proton exchange membrane fuel cellsInternational Journal of Hydrogen Energy, 2012
- Role of Binders in High Temperature PEMFC ElectrodeJournal of the Electrochemical Society, 2011
- Influence of operating temperature on cell performance and endurance of high temperature proton exchange membrane fuel cellsJournal of Power Sources, 2010