Fracture mechanics and relaxation processes in polyvinyl chloride
Author:
- 1 November 1972
- journal article
- research article
- Published by Wiley in Polymer Engineering & Science
- Vol. 12 (6) , 425-431
Abstract
Linear elastic fracture mechanics has been applied to investigate the strain rate sensitivity of polyvinyl chloride over a range of temperatures (−197 to +80°C). Three‐point bend tests have been carried out at two widely different strain rates; in “static” (slow bend) conditions and in a “dynamic” (impact) situation. A specially instrumented Charpy impact hammer has been used to analyse the record of transient loads.The fracture toughness results show a close relationship to the relaxation phenomena between −60 and +75 °C; it was observed that in this region the maximum toughness correlated with the maximum β‐relaxation. It was also found that, while in the region of low temperatures the material showed a considerable degree of strain rate sensitivity, at +50° the dynamic and static toughness were of the same order of magnitude; this behavior differs substantially from that observed in metals.Keywords
This publication has 7 references indexed in Scilit:
- Molecular kinetics and the fracture of PMMAEngineering Fracture Mechanics, 1972
- Time measurement in the fracture toughness studiesEngineering Fracture Mechanics, 1970
- The relations between relaxation spectra, flaw growth, and ultimate properties of PVCEuropean Polymer Journal, 1970
- Fracture toughness measurements by instrumented impact testEngineering Fracture Mechanics, 1969
- Dependence of mechanical properties on molecular motion in polymersPolymer Engineering & Science, 1968
- Beeinflussung des Bruchverhaltens von Hochpolymeren durch molekulare RelaxationsprozesseColloid and Polymer Science, 1966
- Dynamic mechanical behavior of some high polymers at temperatures from 6°K.: Polyethylene, nylon 66, polypropylene, poly(vinyl chloride), poly‐(d,l‐propylene oxide), polybutene‐1, poly(4‐methyl‐pentene‐1), poly(methyl methacrylate), poly(ethyl methacrylate), poly‐4‐methylpentene‐1 and poly(isobutyl methacrylate)Journal of Polymer Science Part A: General Papers, 1964