Foamed cementitious composites with 3D-printed auxetic lattice reinforcement: enhancing static and cyclic performance
Authors:
Open Access
- 11 May 2025
- journal article
- Published by Elsevier in Composites Part B: Engineering
- Vol. 303
Abstract
No abstract availableFunding Information
- European Research Council (101041342)
- China Scholarship Council (202006260045)
This publication has 40 references indexed in Scilit:
- Geometric design and performance of single and dual-printed lattice-reinforced cementitious compositeCement and Concrete Composites, 2023
- Static and dynamic compressive behaviour of 3D printed auxetic lattice reinforced ultra-high performance concreteCement and Concrete Composites, 2023
- Mixed‐Mode Multidirectional Poisson's Ratio Modulation in Auxetic 3D Lattice MetamaterialsAdvanced Engineering Materials, 2022
- Auxetic mechanical metamaterials with diamond and elliptically shaped perforationsActa Mechanica, 2020
- Compressive impact tests of lightweight concrete with 155-mm-diameter spilt hopkinson pressure barCement and Concrete Composites, 2020
- Auxetic, Partially Auxetic, and Nonauxetic Behaviour in 2D Crystals of Hard Cyclic TetramersPhysica Status Solidi (RRL) – Rapid Research Letters, 2020
- Investigation of phase composition and microstructure of foamed cement paste with different supplementary cementing materialsCement and Concrete Composites, 2020
- Experimental research on the performance of lightweight concrete containing foam and expanded clay aggregateComposites Part B: Engineering, 2019
- Investigation of low-velocity impact behaviors of foamed concrete materialComposites Part B: Engineering, 2019
- Auxetic behaviour from rotating rigid unitsPhysica Status Solidi (b), 2005