Class-E MOSFET tuned power oscillator design procedure
Authors:
- V.G. KrizhanovskiVKV.G. Krizhanovski
- J.V. RassokhinaJRJ.V. Rassokhina
- D.V. ChernovDCD.V. Chernov
- 5 July 2005
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Circuits and Systems I: Regular Papers
- Vol. 52 (6) , 1138-1147
Abstract
A complete design procedure of a Class-E oscillator for a duty cycle of 0.5 is presented. It is based on an analytical solution of equations, which describe oscillator operation for steady state. General equations for all oscillator component values are given. Using the proposed procedure, the components were calculated for an example oscillator. The oscillator was built and tested using an MTP3055E power MOSFET. The efficiency and output power versus frequency, and the oscillation frequency versus dc supply voltage were measured. At V/sub DD/=4.5 V, the measured oscillation frequency was 800 kHz, the output power was 0.953 W, and the efficiency was 82%.Keywords
This publication has 8 references indexed in Scilit:
- Class-E MOSFET low-voltage power oscillator2003
- Tuning analysis for the high-Q class-E power amplifierIEEE Transactions on Microwave Theory and Techniques, 2000
- Design of high-efficiency RF Class-D power amplifierIEEE Transactions on Power Electronics, 1994
- Exact analysis of class E tuned power amplifier at any Q and switch duty cycleIEEE Transactions on Circuits and Systems, 1987
- Class E high-efficiency tuned power oscillatorIEEE Journal of Solid-State Circuits, 1981
- Transistor power losses in the class E tuned power amplifierIEEE Journal of Solid-State Circuits, 1978
- Idealized operation of the class E tuned power amplifierIEEE Transactions on Circuits and Systems, 1977
- Harmonic output of class-E RF power amplifiers and load coupling network designIEEE Journal of Solid-State Circuits, 1977