Finite Element Studies of the Influence of Pile-up on the Analysis of Nanoindentation Data
Authors:
- 1 January 1996
- journal article
- Published by Springer Nature in MRS Proceedings
- Vol. 436
Abstract
Methods currently used for analyzing nanoindentation load-displacement data give good predictions of the contact area in the case of hard materials, but can underestimate the contact area by as much as 40% for soft materials which do not work harden. This underestimation results from the pile-up which forms around the hardness impression and leads to potentially significant errors in the measurement of hardness and elastic modulus. Finite element simulations of conical indentation for a wide range of elastic-plastic materials are presented which define the conditions under which pile-up is significant and determine the magnitude of the errors in hardness and modulus which may occur if pile-up is ignored. It is shown that the materials in which pile-up is not an important factor can be experimentally identified from the ratio of the final depth after unloading to the depth of the indentation at peak load, a parameter which also correlates with the hardness-to-modulus ratio.Keywords
This publication has 3 references indexed in Scilit:
- Influences of stress on the measurement of mechanical properties using nanoindentation: Part II. Finite element simulationsJournal of Materials Research, 1996
- An improved technique for determining hardness and elastic modulus using load and displacement sensing indentation experimentsJournal of Materials Research, 1992
- The relation between load and penetration in the axisymmetric boussinesq problem for a punch of arbitrary profileInternational Journal of Engineering Science, 1965