Height Effect on Heat-Transfer Characteristics of Aluminum-Foam Heat Sinks
Authors:
- 12 October 2005
- journal article
- Published by Wiley in Journal of Heat Transfer
- Vol. 128 (6) , 530-537
Abstract
This study investigates and demonstrates the two conflicting effects of the height on the cooling performance of aluminum-foam heat sinks, under the impinging-jet flow condition. In addition, the nonlocal thermal equilibrium phenomena are also investigated. When the H∕D (the height to diameter ratio) of the aluminum-foam heat sinks is reduced from 0.92 to 0.15, the Nusselt number of aluminum-foam heat sinks is found to first increase and then decrease. The increase in the Nusselt number is caused by the increased percentage of the cooling air reaching the top surface of the waste-heat generation block, resulting from the reduced flow resistance. The decrease in the Nusselt number is mainly caused by the reduction in the heat-transfer area between the cooling air and the solid phase of the aluminum-foam heat sink. As the porosity and pore density decrease, the Nusselt number increases and the convective heat transfer is enhanced. The correlation between the Nusselt and Reynolds numbers for each of the 15 samples studied in this work is reported. For samples with a H∕D>0.31, the temperature difference between the solid and gas phases of aluminum-foam heat sinks decreases with the increase of the distance from the heated surface. The non-local thermal equilibrium regime is observed to exist at low Reynolds number and small dimensionless height. On the other hand, for samples with a H∕D⩽0.31, the temperature difference first increases and then decreases with the increase of the distance from the heated surface; the maximum temperature difference is located at z∕H≒0.25 and is independent of the Reynolds number.Keywords
This publication has 17 references indexed in Scilit:
- Experimental investigation of heat-transfer characteristics of aluminum-foam heat sinksInternational Journal of Heat and Mass Transfer, 2004
- Experimental research on convection heat transfer in sintered porous plate channelsInternational Journal of Heat and Mass Transfer, 2004
- Properties of ceramic foam catalyst supports: pressure dropApplied Catalysis A: General, 2000
- Heat-transfer analysis and thermal dispersion in thermally-developing region of a sintered porous metal channelInternational Journal of Heat and Mass Transfer, 2000
- STAGNATION REGION HEAT TRANSFER OF A TURBULENT AXISYMMETRIC JET IMPINGEMENTExperimental Heat Transfer, 1999
- Experimental and theoretical studies of convective heat transfer in a cylindrical porous mediumInternational Journal of Heat and Fluid Flow, 1998
- Numerical study of a low permeability microporous heat sink for cooling phased-array radar systemsInternational Journal of Heat and Mass Transfer, 1996
- Heat Transfer Measurement and Analysis for Sintered Porous ChannelsJournal of Heat Transfer, 1994
- Analysis of dispersion effects and non-thermal equilibrium, non-Darcian, variable porosity incompressible flow through porous mediaInternational Journal of Heat and Mass Transfer, 1994
- Analysis of Energy and Momentum Transport for Fluid Flow Through a Porous BedJournal of Heat Transfer, 1990