Maximizing throughput over parallel wire structures in the deep submicrometer regime
Authors:
- 1 April 2003
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Very Large Scale Integration (VLSI) Systems
- Vol. 11 (2) , 224-243
Abstract
In a parallel multiwire structure, the exact spacing and size of the wires determine both the resistance and the distribution of the capacitance between the ground plane and the adjacent signal carrying conductors, and have a direct effect on the delay. Using closed-form equations that map the geometry to the wire parasitics and empirical switch factor based delay models that show how repeaters can be optimized to compensate for dynamic effects, we devise a method of analysis for optimizing throughput over a given metal area. This analysis is used to show that there is a clear optimum configuration for the wires which maximizes the total bandwidth. Additionally, closed form equations are derived, the roots of which give close to optimal solutions. It is shown that for wide buses, the optimal wire width and spacing are independent of the total width of the bus, allowing easy optimization of on-chip buses. Our analysis and results are valid for lossy interconnects as are typical of wires in submicron technologies.Keywords
This publication has 48 references indexed in Scilit:
- On-chip wiring design challenges for gigahertz operationProceedings of the IEEE, 2001
- The future of wiresProceedings of the IEEE, 2001
- Repeater design to reduce delay and power in resistive interconnectIEEE Transactions on Circuits and Systems II: Analog and Digital Signal Processing, 1998
- A multilevel parasitic interconnect capacitance modeling and extraction for reliable VLSI on-chip clock delay evaluationIEEE Journal of Solid-State Circuits, 1998
- Interconnect and substrate modeling and analysis: an overviewIEEE Journal of Solid-State Circuits, 1998
- When are transmission-line effects important for on-chip interconnections?IEEE Transactions on Microwave Theory and Techniques, 1997
- Optimum buffer circuits for driving long uniform linesIEEE Journal of Solid-State Circuits, 1991
- Line-to-ground capacitance calculation for VLSI: a comparisonIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 1988
- An analysis of interconnect line capacitance and coupling for VLSI circuitsSolid-State Electronics, 1984
- Signal Delay in RC Tree NetworksIEEE Transactions on Computer-Aided Design of Integrated Circuits and Systems, 1983