Development of a Flexible Dielectric Sensor for Flow Monitoring of the Liquid Resin Infusion Process
Open Access
Abstract
The analysis and design of a novel flexible dielectric sensor, which can be integrated into a composite materials manufacturing process to measure the resin frontal flow, is presented in this paper. The proposed sensor consists of two parallel line electrodes and a ground plane covered by a dielectric material. The analytical description and the electrostatic modelling were considered for the design of the sensor and to enhance the understanding of the response of the sensor to the resin impregnation of a carbon fabric during the infusion phase. The optimization of the sensor’s response and the increase of its sensitivity with regards to the geometric characteristics and the materials used were the main objectives of this study. An experimental set-up for the vacuum infusion process which includes the proposed sensor was used to measure the capacitance and validate the derived resin flow against visual measurements. The results indicate that the sensor can provide information on the resin frontal flow within 2% accuracy against visual measurements, which make this technology promising for monitoring the liquid resin infusion processes.Keywords
Funding Information
- Engineering and Physical Sciences Research Council (EP/L014998/1)
- Horizon 2020 Framework Programme (686493)
This publication has 40 references indexed in Scilit:
- Uncertainty in the manufacturing of fibrous thermosetting composites: A reviewComposites Part A: Applied Science and Manufacturing, 2014
- A methodology for flow-front estimation in LCM processes based on pressure sensorsComposites Part A: Applied Science and Manufacturing, 2013
- Constraints on monitoring resin flow in the resin transfer molding (RTM) process by using thermocouple sensorsComposites Part A: Applied Science and Manufacturing, 2007
- Monitoring of resin flow in the resin transfer molding (RTM) process using point-voltage sensorsComposites Science and Technology, 2007
- Linear direct current sensing system for flow monitoring in Liquid Composite MouldingComposites Part A: Applied Science and Manufacturing, 2002
- An experimental study of the permeability and capillary pressure in resin-transfer mouldingComposites Science and Technology, 2001
- Sensor placement study for online flow monitoring in liquid composite moldingPolymer Composites, 2000
- A dielectric sensor for measuring flow in resin transfer mouldingMeasurement Science and Technology, 1999
- Use of a simple, inexpensive pressure sensor to measure hydrostatic resin pressure during processing of composite laminatesPolymer Composites, 1999
- Lineal Sensors for Flow Sensing in Liquid Injection Molding of CompositesJournal of Materials Processing & Manufacturing Science, 1999