Comparison of methods for quantifying dental wear caused by erosion and abrasion
- 6 November 2012
- journal article
- research article
- Published by Wiley in Microscopy Research and Technique
- Vol. 76 (2) , 178-183
Abstract
Various methods have been applied to evaluate the effect of erosion and abrasion. So, the aim of this study was to check the applicability of stylus profilometry (SP), surface hardness (SH) and focus‐variation 3D microscopy (FVM) to the analysis of human enamel and dentin subjected to erosion/abrasion. The samples were randomly allocated into four groups (n = 10): G1‐enamel/erosion, G2‐enamel/erosion plus abrasion, G3‐dentin/erosion, and G4‐dentin/erosion plus abrasion. The specimens were selected by their surface hardness, and they were subjected to cycles of demineralization (Coca‐Cola®‐60 s) and remineralization (artificial saliva‐60 min). For groups G2 and G4, the remineralization procedures were followed by toothbrushing (150 strokes). The above cycle was repeated 3×/day during 5 days. The samples were assessed using SH, SP, and FVM. For each substrate, the groups were compared using an unpaired t‐test, and Pearson correlation coefficients were calculated (α = 5%). For enamel, both profilometry technique showed greater surface loss when the erosion and abrasion processes were combined (P <0.05). The correlation analysis did not reveal any relationships among SH, SP, and FVM to G2 and G4. There were significant correlation coefficients (–0.70 and –0.67) for the comparisons between the FVM and SH methods in enamel and dentin, respectively, in G1 and G3. Choosing the ideal technique for the analysis of erosion depends on the type of dental substrate. SP was not sufficiently sensitive to measure the effects on dentin of erosion or erosion/abrasion. However, SP, FVM and SH were adequate for the detection of tissue loss and demineralization in enamel. Microsc. Res. Tech., 2013.Keywords
This publication has 29 references indexed in Scilit:
- Energy dispersive X‐ray spectrometry study of the protective effects of fluoride varnish and gel on enamel erosionMicroscopy Research and Technique, 2010
- A comparison of two-dimensional and three-dimensional measurements of wear in a laboratory investigationDental Materials, 2010
- Comparing two quantitative methods for studying remineralization of artificial cariesJournal of Dentistry, 2010
- Quantifying and qualifying surface changes on dental hard tissues in vitroJournal of Dentistry, 2010
- Comparison of Calcium Analysis, Longitudinal Microradiography and Profilometry for the Quantitative Assessment of Erosion in DentineCaries Research, 2009
- Effects of tooth whitening and orange juice on surface properties of dental enamelJournal of Dentistry, 2009
- Assessing fluoride treatment and resistance of dental enamel to soft drink erosion in vitro: Applications of focus variation 3D scanning microscopy and stylus profilometryJournal of Dentistry, 2009
- Analysis of the erosive potential of calcium‐containing acidic beveragesEuropean Journal of Oral Sciences, 2008
- Comparison of Calcium/Phosphorus Analysis, Longitudinal Microradiography and Profilometry for the Quantitative Assessment of Erosive DemineralisationCaries Research, 2005
- The laboratory assessment of enamel erosion: a reviewJournal of Dentistry, 2004