A Polysulfide-Trapping Interface for Electrochemically Stable Sulfur Cathode Development
- 10 February 2016
- journal article
- research article
- Published by American Chemical Society (ACS) in ACS Applied Materials & Interfaces
- Vol. 8 (7) , 4709-4717
Abstract
Lithium–sulfur (Li–S) cells have a strong edge to become an inexpensive, high-capacity rechargeable battery system. However, currently, several prohibitive challenges occur within the sulfur core, especially the polysulfide-diffusion problem. To address these scientific issues, we present here a boron-doped multiwalled carbon nanotube coated separator (B-CNT-coated separator). The B-CNT-coated separator creates a polysulfide trap between the pure sulfur cathode and the polymeric separator as a “polysulfide-trapping interface,” stabilizing the active material and allowing the dissolved polysulfides to activate the bulk sulfur cores. Therefore, the dissolved polysulfides change from causing fast capacity fade to assisting with the activation of bulk sulfur clusters in pure sulfur cathodes. Moreover, the heteroatom-doped polysulfide-trapping interface is currently one of the missing pieces of carbon-coated separators, which might inspire further studies in its effect and battery chemistry. Li–S cells employing B-CNT-coated separators (i) exhibit improved cyclability at various cycling rates from 0.2C to 1.0C rate and (ii) attain a high capacity retention rate of 60% with a low capacity fade rate of 0.04% cycle–1 after 500 cycles. We believe that our B-CNT-coated separator could light up a new research area for integrating heteroatom-doped carbon into the flexible, lightweight, carbon-coated separator.Keywords
Funding Information
- Division of Engineering Education and Centers (EEC-1160494)
This publication has 39 references indexed in Scilit:
- Ionic shield for polysulfides towards highly-stable lithium–sulfur batteriesEnergy & Environmental Science, 2013
- Doping carbons beyond nitrogen: an overview of advanced heteroatom doped carbons with boron, sulphur and phosphorus for energy applicationsEnergy & Environmental Science, 2013
- Sulfur‐Infiltrated Micro‐ and Mesoporous Silicon Carbide‐Derived Carbon Cathode for High‐Performance Lithium Sulfur BatteriesAdvanced Materials, 2013
- Does the sulfur cathode require good mixing for a liquid electrolyte lithium/sulfur cell?Electrochemistry Communications, 2013
- Carbon–sulfur composites for Li–S batteries: status and prospectsJournal of Materials Chemistry A, 2013
- Challenges and Prospects of Lithium–Sulfur BatteriesAccounts of Chemical Research, 2012
- Lithium/Sulfur Cell Discharge Mechanism: An Original Approach for Intermediate Species IdentificationAnalytical Chemistry, 2012
- A new direction for the performance improvement of rechargeable lithium/sulfur batteriesJournal of Power Sources, 2012
- Advances in Li–S batteriesJournal of Materials Chemistry, 2010
- Polysulfide Shuttle Study in the Li/S Battery SystemJournal of the Electrochemical Society, 2004