High-quality cutting of polished single-crystal silicon by wire electrical discharge machining
Authors:
- Hideo TakinoHTHideo Takino
- Toshimitsu IchinoheTIToshimitsu Ichinohe
- Katsunori TanimotoKTKatsunori Tanimoto
- Syuichi YamaguchiSYSyuichi Yamaguchi
- Kazushi NomuraKNKazushi Nomura
- Masanori KuniedaMKMasanori Kunieda
- 1 October 2005
- journal article
- Published by Elsevier in Precision Engineering
- Vol. 29 (4) , 423-430
Abstract
No abstract availableThis publication has 12 references indexed in Scilit:
- Fabrication of a complex-shaped mirror for an extreme ultraviolet lithography illumination systemOptical Engineering, 2003
- Fabrication of Large-Diameter Single-Crystal Silicon Aspheric Lens by Straight-Line Enveloping Diamond-Turning Method.Journal of the Japan Society for Precision Engineering, 2002
- An empirical survey on the influence of machining parameters on tool wear in diamond turning of large single-crystal silicon opticsPrecision Engineering, 2001
- Novel illumination system for EUVL2000
- Design, fabrication, and testing of lightweight silicon mirrors1999
- Chip Morphology of Ultra-Precision Diamond Turning of Single Crystal Slicon.Journal of the Japan Society for Precision Engineering, 1999
- Fabrication and metrology of high-quality synchrotron mirrors in the sub-arcsec regime1997
- Study on Aspherical Surface Polishing of Single Crystal Silicon Lens.Journal of the Japan Society for Precision Engineering, 1997
- Diamond turning of silicon optics1996
- High-precision large-diameter single-crystal silicon spheres: their fabrication and measurements of sphericity1995