Erosion of A356.2 alloy by SiO2 particles
Authors:
- 1 March 1997
- journal article
- research article
- Published by Taylor & Francis in International Journal of Cast Metals Research
- Vol. 9 (6) , 337-343
Abstract
Automatic moulding has been widely applied in the casting industry, but erosive wear of moulding dies occurs when being filled with SiO2 sand. A356 alloys have often been used as the die material although their erosion behaviours are still unclear. In this investigation, SiO2 sand erosion of A356.2 alloy in the as-cast, naturally aged and artificially aged conditions was studied by varying the impact angle and choosing two pressures (0.15 and 0.3 MPa) of compressed air to carry the sand particles. The results indicate typical ductile erosion behaviour in which the maximum erosion rate occurs at oblique impact angles of about 20° to 25°, although both ductile wear mechanisms and brittle cracking of eutectic Si particles are present. Despite the improvement of the mechanical properties, the erosion resistance of the naturally aged specimens is only compatible to that of the as-cast specimens, and the artificially aged specimens show the greatest erosion rate at an air pressure of 0.3 MPa. Erosion of the artificially aged specimens also leads to a softening effect by dissolution of the Mg2Si particles.Keywords
This publication has 9 references indexed in Scilit:
- The erosion behaviour of an aluminium-lithium alloyScripta Metallurgica et Materialia, 1992
- Effects of microstructure on the erosion of Al-Si alloys ny solid particlesMetallurgical Transactions A, 1987
- Erosion-induced whisker growth on aluminumScripta Metallurgica, 1985
- Effect of microstructure on the erosion of steel by solid particlesWear, 1985
- Occurrence of melting during the solid particle erosion of copperWear, 1981
- Particle size threshold in the erosion of metalsWear, 1981
- The effect of mechanical surface and heat treatments on the erosion resistance of 6061 aluminum alloyWear, 1981
- Erosion of a strong aluminum alloyWear, 1979
- Erosion Prediction in Turbomachinery Resulting from Environmental Solid ParticlesJournal of Aircraft, 1975