Effects of Interfacial Reactions on Microstructures and Mechanical Properties of 3003 Al/T2 Cu and 1035 Al/T2 Cu Brazed Joints
Author:
Open Access
Abstract
To meet the demand for efficient and reliable copper and aluminum (Cu/Al) joints in refrigeration and electric power industries, interfacial reactions in 3003 Al/T2 Cu and 1035 Al/T2 Cu joints brazed by Zn-xAl (x ranged from 2–25 wt.%) filler metals and their effects on the mechanical properties of the joints were investigated. Microstructures and fracture surfaces were observed combining with composition analysis. For 3003 Al/Cu joints, bulk CuAl and CuAl2 intermetallic compound (IMC) formed in brazing seams, and a CuAl IMC layer formed at the Cu side interfaces. For 1035 Al/Cu joints, bulk CuAl2 IMC formed in brazing seams, and an Al4.2Cu3.2Zn0.7 IMC layer formed at the Cu side interfaces. For both kinds of joints, shear strength increased first, then decreased with the increasing Al content. The increase in shear strength was because Al promoted the formation of Cu-Al IMC, and caused dispersion strengthening. With the excessive Al content, however, the bulk IMC became coarse and the IMC layers at Cu side interfaces grew thick, causing the joint strength to decrease due to stress concentration. The strength of 3003 Al/Cu joints was always higher than that of 1035 Al/Cu, and their highest strength were achieved by Zn-12Al and Zn-15Al, respectively.Keywords
This publication has 30 references indexed in Scilit:
- Optimization of Process Parameters for Friction Stir Welding of Aluminum and Copper Using the Taguchi MethodMetals, 2019
- Weldability and shear strength feasibility study for automotive electric vehicle battery tab interconnectsJournal of the Brazilian Society of Mechanical Sciences and Engineering, 2019
- Influence of the degree of dilution with laser beam vacuum-welded Cu-Al mixed joints on the electrical propertiesProcedia CIRP, 2018
- Microstructures and mechanical behavior of aluminum-copper lap jointsMaterials Science and Engineering: A, 2017
- Effect of lap configuration on the microstructure and mechanical properties of dissimilar ultrasonic metal welded copper-aluminum jointsJournal of Materials Processing Technology, 2017
- Dissimilar friction stir welding of 6061 Al to T2 pure Cu adopting tooth-shaped joint configuration: Microstructure and mechanical propertiesMaterials Science and Engineering: A, 2017
- Evolving properties of friction stir spot welds between AA1060 and commercially pure copper C11000Transactions of Nonferrous Metals Society of China, 2016
- Investigation of interdiffusion and intermetallic compounds in Al–Cu joint produced by continuous drive friction weldingEngineering Science and Technology, an International Journal, 2016
- Investigation on dissimilar underwater friction stir lap welding of 6061-T6 aluminum alloy to pure copperMaterials & Design (1980-2015), 2014
- Effect of zinc interlayer on ultrasonic spot welded aluminum-to-copper jointsMaterials Science and Engineering: A, 2014