Fabrication of PES Modified by TiO2/Na2Ti3O7 Nanocomposite Mixed-Matrix Woven Membrane for Enhanced Performance of Forward Osmosis: Influence of Membrane Orientation and Feed Solutions
Open Access
Abstract
Water treatment is regarded as one of the essential elements of sustainability. To lower the cost of treatment, the wastewater volume is reduced via the osmotic process. Here, mixed-matrix woven forward osmosis (MMWFO) PES membranes modified by a TiO2/Na2Ti3O7 (TNT) nanocomposite were fabricated for treating water from different sources. Various techniques were used to characterize the TNT nanocomposite. The crystal structure of TNT is a mix of monoclinic Na2Ti3O7 and anorthic TiO2 with a preferred orientation of (). The SEM image shows that the surface morphology of the TNT nanocomposite is a forked nano-fur with varying sizes regularly distributed throughout the sample. The impact of TNT wt.% on membrane surface morphologies, functional groups, hydrophilicity, and performance was investigated. Additionally, using distilled water (DW) as the feed solution (FS), the effects of various NaCl concentrations, draw solutions, and membrane orientations on the performance of the mixed-matrix membranes were tested. Different water samples obtained from various sources were treated as the FS using the optimized PES/TNT (0.01 wt.%) MMWFO membrane. Using textile effluent as the FS, the impact of various NaCl DS concentrations on the permeated water volume was investigated. The results show that the MMWFO membrane generated with the TNT nanocomposite at a 0.01 wt.% ratio performed better in FO mode. After 30 min of use with 1 M NaCl and various sources of water as the FS, the optimized MMWFO membrane provided a steady water flow and exhibited antifouling behavior. DW performed better than other water types whenever it was used owing to its greater flow (136 LMH) and volume reduction (52%). Tap water (TW), textile industrial wastewater (TIWW), gray water (GW), and municipal wastewater (MW) showed volume reductions of 41%, 34%, 33%, and 31.9%, respectively. Additionally, when utilizing NaCl as the DS and TIWW as the FS, 1 M NaCl resulted in more permeated water than 0.25 M and 0.5 M, yet a higher volume reduction of 41% was obtained.
Keywords
Funding Information
- Princess Nourah Bint Abdulrahman University (PNURSP2023R67)
This publication has 89 references indexed in Scilit:
- Nanocomposite substrates for controlling internal concentration polarization in forward osmosis membranesJournal of Membrane Science, 2013
- Enhanced hydrophilicity and salt rejection study of graphene oxide-polysulfone mixed matrix membraneDesalination, 2013
- Biofouling of Water Treatment Membranes: A Review of the Underlying Causes, Monitoring Techniques and Control MeasuresMembranes, 2012
- High Performance Thin-Film Composite Forward Osmosis Hollow Fiber Membranes with Macrovoid-Free and Highly Porous Structure for Sustainable Water ProductionEnvironmental Science & Technology, 2012
- Synthesis and characterization of flat-sheet thin film composite forward osmosis membranesJournal of Membrane Science, 2011
- Characterization of novel forward osmosis hollow fiber membranesJournal of Membrane Science, 2010
- Coupled effects of internal concentration polarization and fouling on flux behavior of forward osmosis membranes during humic acid filtrationJournal of Membrane Science, 2010
- Preparation of Carbon Membranes for Gas Separation2010
- Fabrication and characteristics of bioactive sodium titanate/titania graded film on NiTi shape memory alloyJournal of Biomedical Materials Research Part A, 2005
- Effect of membrane characteristics on mass and heat transfer in the osmotic evaporation processJournal of Membrane Science, 2004