Effect of Microstructural Evolution on Mechanical Properties and Fracture Modes of AlSi10Mg Blocks Fabricated by Selective Laser Melting after Stress Relief Annealing
Authors:
- 14 September 2022
- journal article
- research article
- Published by Wiley in Advanced Engineering Materials
- Vol. 24 (12)
Abstract
AlSi10Mg parts fabricated by selective laser melting (SLM) are frequently reported to have heterogeneous microstructures. How this affects the mechanical properties of SLM parts still requires further study. Herein, AlSi10Mg blocks with simple cuboid shape are printed and annealed at 300 °C. Their microstructure changes significantly from edge to center and from top to bottom. Low‐temperature annealing is not sufficient to eliminate structural heterogeneity. Before annealing, the Si‐rich phase is fine and mainly exists in the form of a eutectic network. The as‐printed blocks have high tensile strength, and the fracture surface exhibits a mix of transcellular pits and pores. After annealing, the network structure is completely broken or disappeared in most locations in the blocks. The Si‐rich phase is significantly coarsened and even segregated locally along the melt pool boundaries. Yield strength is reduced by 25%–47%, but elongation values are doubled. Tensile samples are fractured by an along‐the‐pool boundary fracture mode along the boundary. Micropores formed during the printing process are aggregated in the about 200 μm thick outer surface layer of the block. They also have a significant effect on the local elongation both before and after annealing.Keywords
Funding Information
- Natural Science Foundation of Shandong Province (ZR2021ME089)
This publication has 24 references indexed in Scilit:
- A comparison of Selective Laser Melting with bulk rapid solidification of AlSi10Mg alloyJournal of Alloys and Compounds, 2018
- Galvanostatic Anodizing of Additive Manufactured Al-Si10-Mg AlloyJournal of the Electrochemical Society, 2017
- Evaluation of the stress-strain relationship of constituent phases in AlSi10Mg alloy produced by selective laser melting using crystal plasticity FEMJournal of Alloys and Compounds, 2017
- Formation and reduction of hydrogen porosity during selective laser melting of AlSi10MgJournal of Materials Processing Technology, 2015
- Processing AlSi10Mg by selective laser melting: Parameter optimisation and material characterisationMaterials Science and Technology, 2015
- On the Precipitation Hardening of Selective Laser Melted AlSi10MgMetallurgical and Materials Transactions A, 2015
- Reducing porosity in AlSi10Mg parts processed by selective laser meltingAdditive Manufacturing, 2014
- Metal Additive Manufacturing: A ReviewJournal of Materials Engineering and Performance, 2014
- Microstructure and mechanical properties of Al–12Si produced by selective laser melting: Effect of heat treatmentMaterials Science and Engineering: A, 2014
- Fine-structured aluminium products with controllable texture by selective laser melting of pre-alloyed AlSi10Mg powderActa Materialia, 2013