Stabilization of Platinum Anode Catalyst in a H[sub 2]S-O[sub 2] Solid Oxide Fuel Cell with an Intermediate TiO[sub 2] Layer
Authors:
- 1 January 2002
- journal article
- Published by The Electrochemical Society in Journal of the Electrochemical Society
- Vol. 149 (7) , A808-A814
Abstract
The performance of supported platinum as an anode catalyst in a hydrogen sulfide solid oxide fuel cell with yttria-stabilized zirconia (YSZ) as the electrolyte has been examined in the temperature range of 700-900°C. The highest current density achieved at 800°C was 100 mA/cm2 and the highest power density was 15.4 mW/cm2, when operated with 5% H2SH2S feed. Increasing the concentration of H2SH2S in the anode feed did not improve the performance of the cell, due to corruption of the platinum anode; the reversible formation and decomposition of PtS on the platinum-YSZ interface led to instability of the electrochemical interface of the Pt catalyst with the YSZ electrolyte. The membrane structure and performance were both stabilized by interposing a thin layer of TiO2TiO2 between the Pt anode and YSZ electrolyte. The stabilized open-circuit voltage value depended on flow rates of the anode and cathode feeding gases. This behavior is attributed to the crossover of reactants, which change the partial pressures of product SO2SO2 and H2O.H2O. © 2002 The Electrochemical Society. All rights reserved.Keywords
This publication has 24 references indexed in Scilit:
- Anode Materials for a Hydrogen Sulfide Solid Oxide Fuel CellJournal of the Electrochemical Society, 1999
- A proton-conducting solid state H2S—O2 fuel cell. 1. anode catalysts, and operation at atmospheric pressure and 20–90°CInternational Journal of Hydrogen Energy, 1998
- Utilization of Hydrogen Sulfide in an Intermediate‐Temperature Ceria‐Based Solid Oxide Fuel CellJournal of the Electrochemical Society, 1998
- Phase Relation of ZrO2-YO1.5-TiO2 Ceramics Prepared by Sol-Gel MethodJournal of the Ceramic Society of Japan, 1998
- A Hydrogen Sulfide Fuel Cell Using a Proton‐Conducting Solid ElectrolyteJournal of the Electrochemical Society, 1996
- A Hydrogen Sulfide Solid‐Oxide Fuel Cell Using Ceria‐Based ElectrolytesJournal of the Electrochemical Society, 1993
- An Electrochemical Claus Process for Sulfur RecoveryJournal of the Electrochemical Society, 1989
- Chemical Cogeneration in Solid Electrolyte Cells: The Oxidation of toJournal of the Electrochemical Society, 1989
- A Direct H 2 S / Air Solid Oxide Fuel CellJournal of the Electrochemical Society, 1987
- Surface reactions of sulfur with oxygen on Pt(111)Surface Science, 1982