Strengths and ductility of Mo–TiC alloys after secondary recrystallization
Author:
- Yutaka HiraokaYHYutaka Hiraoka
- 1 September 2003
- journal article
- Published by Elsevier in International Journal of Refractory Metals and Hard Materials
- Vol. 21 (5-6) , 265-270
Abstract
No abstract availableKeywords
This publication has 10 references indexed in Scilit:
- Grain Growth Behavior in Mo-0.2 mass%Ti AlloyMaterials Transactions, JIM, 1995
- Low temperature fracture strength and ductility of carburized Mo-Ti alloysInternational Journal of Refractory Metals and Hard Materials, 1995
- Effect of Ti in Solution on Ductile-Brittle Transition Characteristics of Powder-Metallurgy Molybdenum AlloysJournal of the Japan Institute of Metals and Materials, 1994
- Effects of complex additions of Re or Ti with C on the strength and ductility of recrystallized molybdenumInternational Journal of Refractory Metals and Hard Materials, 1993
- Effect of TiC Addition on the Intergranular Brittleness in MolybdenumMaterials Transactions, JIM, 1989
- Crack Generation and Propagation Characteristics of Molybdenum Single CrystalsTransactions of the Japan Institute of Metals, 1985
- Bend properties of molybdenum single-crystal sheets produced by the secondary recrystallization method (role of island grains)Journal of the Less Common Metals, 1984
- Effects of rolling procedures on the development of annealing textures in molybdenum sheetsJournal of the Less Common Metals, 1984
- Preparation of a large-scale molybdenum single-crystal sheet by means of secondary recrystallizationJournal of the Less Common Metals, 1984
- Effect of Alloying Elements on the Nil Ductility Transition Temperature of MolybdenumJournal of the Japan Institute of Metals and Materials, 1984