Trigger Board for the Auger Surface Detector With 100 MHz Sampling and Discrete Cosine Transform
Author:
- 28 March 2011
- journal article
- Published by Institute of Electrical and Electronics Engineers (IEEE) in IEEE Transactions on Nuclear Science
- Vol. 58 (4) , 1692-1700
Abstract
The surface detector array of the Pierre Auger Observatory contains 1600 water Cherenkov detectors spread over an area of 3000 km2. The Cherenkov light is detected by three 9-inch photomultiplier tubes from which the signals of the anode and last dynode are digitized by 10 bit ADCs. The currently used Front-End Boards equipped with the ACEX® and Cyclone® FPGA are sampled with 40 MHz. New requirements from the Auger North (100 MHz) and AMIGA (80 MHz) specification as well as the proposal of new spectral triggers based on the 16-point Discrete Cosine Transform (DCT) impose a new Front End Boards with more powerful FPGA chip with a sufficient amount of DSP blocks. The DCT trigger allows recognition of ADC traces with a very short rise time and fast exponential attenuation related to a narrow, flat muon component of very inclined extensive air showers generated by hadrons and starting their development early in the atmosphere. Ten prototype boards equipped with Altera® Cyclone® III FPGA have been fabricated and successively tested in the lab and in real pampas conditions in six test surface detectors within April 19 - July 26, 2009. Boards contain only a single FPGA chip, which implements also the slow channel, in previous three generations supported by the external Dual-Port RAM. Tests confirmed full stability and high reliability of the digital part. Both lab and field tests confirm a high efficiency of the recognition of expected patterns of ADC traces.Keywords
This publication has 9 references indexed in Scilit:
- An FPGA based trigger and RFI filter for radio detection of cosmic rays2010
- Triggers, data flow and the synchronization between the Auger surface detector and the AMIGA underground muon counters2010
- The 3rd generation Front-End cards of the Pierre Auger surface detectors: Test results and performance in the fieldNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2009
- A spectral 1st level FPGA trigger for detection of very inclined showers based on a 16-point discrete cosine transform for the Pierre Auger ObservatoryNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2009
- 16-point discrete Fourier transform based on the Radix-2 FFT algorithm implemented into cyclone FPGA as the UHECR trigger for horizontal air showers in the Pierre Auger ObservatoryNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2006
- The concept of an cost-effective first level surface detector trigger in the Pierre Auger ObservatoryNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2005
- Development of a new first level trigger for the surface array in the Pierre Auger Observatory based on the CycloneTM Altera FPGANuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2005
- Implementation of the first level surface detector trigger for the Pierre Auger Observatory Engineering ArrayNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2005
- Properties and performance of the prototype instrument for the Pierre Auger ObservatoryNuclear Instruments and Methods in Physics Research Section A: Accelerators, Spectrometers, Detectors and Associated Equipment, 2004