Fluid Temperature and Film Coefficient Prediction and Measurement in Mechanical Face Seals—Experimental Results
Authors:
- 1 January 1998
- journal article
- research article
- Published by Taylor & Francis in Tribology Transactions
- Vol. 41 (4) , 411-422
Abstract
Experiments were run where the temperature of the sealed fluid was measured in a seal chamber in a plane moving in the radial and axial directions. Temperatures within the nonrotating mating ring were also measured. Tests were run at various speeds, flush flow rates, and flush flow directions in water and oil. Details of the experimental apparatus, procedure, operating conditions, and the test results are summarized in the paper. The experimental results confirm the computational fluid dynamics (CFD) predicted results made based on the model presented in the previous paper entitled 'Fluid Temperature and Film Coefficient Prediction and Measurement in Mechanical Face Seals–Theoretical Results” in most respects. Several important conclusions were reached. For flush flow-cooled seals, the fluid temperature surrounding the seal is nearly uniform with small increases occurring only very near to the seal interface. The heat generated by the seal interface and by viscous dissipation in the sealed fluid is taken up by the fluid flow almost immediately upon entry of the flush fluid. Both experiments and modeling show the strong effect of flush flow rate on seal temperatures.Keywords
This publication has 4 references indexed in Scilit:
- Experimental Determination of the Thermal Characteristics of a Mechanical Seal and Its Operating EnvironmentTribology Transactions, 1997
- An experimental-computational investigation of the heat transfer in mechanical face sealsInternational Journal of Heat and Mass Transfer, 1991
- An Experimental and Theoretical Study of Pressure and Thermal Distortions in a Mechanical SealA S L E Transactions, 1986
- Analysis of Plate Vibrations Using SuperelementsJournal of Mechanical Design, 1982