Analysis of the Welding Type and Filler Metal Influence on Performance of a Regenerated Gear
Open Access
Abstract
This paper presents the results of voluminous experimental investigations conducted to analyze the influence of the welding procedure on the performance of regenerated gears. Cylindrical spur gears were tested, both newly manufactured and regenerated, in two fundamentally different ways: by hard facing (surfacing) with the “hard” filler metal (DUR 600-IG) and with the “soft” filler metal (EVB2CrMo) with subsequent cementation and quenching. The regeneration procedures were defined and executed, while, subsequently, the microstructure and microhardness of the hard-faced layers were established and measured, followed by checking the durability of the hard-faced teeth flanks. Finally, techno-economic analysis was performed to establish the rationality of the conducted regenerations, i.e., the costs of regenerated and newly manufactured teeth were compared. Based on the results of the conducted investigations, it was possible to establish the influence of the welding type on the performance characteristics (primarily the service life) of the regenerated gears. For individual reparatory hard facing, the procedure with the “hard” filler metal exhibited better characteristics, while for batch reparation of numerous damaged gears, the reparation with the “soft” filler metal, followed by cementation and heat treatment, might be more convenient.Keywords
Funding Information
- Politechnika Czestochowska (BS/PB-1-100/3010/2021/P)
- Innovative Solu-419 tions for Propulsion, Power and Safety Components of Transport Vehicles (ITMS 313011V334)
- European Regional 421 Development Fund and projects (TR35006 and TR35024)
This publication has 17 references indexed in Scilit:
- Hardfacing and its effect on wear and corrossion performance of various ferrous welded mild steelsMaterials Today: Proceedings, 2021
- Gear fault models and dynamics-based modelling for gear fault detection – A reviewEngineering Failure Analysis, 2020
- New approach for gear mesh stiffness evaluation of spur gears with surface defectsEngineering Failure Analysis, 2020
- Failure investigation of a crane gear damageEngineering Failure Analysis, 2020
- Fault Analysis of Gearboxes in Open Pit MineApplied Engineering Letters : Journal of Engineering and Applied Sciences, 2020
- Wear performance of Fe-Cr-C-B hardfacing coatings: Dry sand/rubber wheel test and ball-on-disc testInternational Journal of Refractory Metals and Hard Materials, 2018
- Wear Resistance of Fe-based Nanostructured HardfacingProcedia Materials Science, 2015
- Effect of cerium on abrasive wear behaviour of hardfacing alloyJournal of Rare Earths, 2012
- Effects of rare earth oxide on hardfacing metal microstructure of medium carbon steel and its refinement mechanismJournal of Rare Earths, 2011
- Effects of RE oxide on the microstructure of hardfacing metal of the large gearMaterials Science and Engineering: A, 2009