Recognition of the flysch substrate using the electrical resistivity tomography (ERT) method to assess the effectiveness of the injection process
Open Access
- 10 May 2023
- journal article
- research article
- Published by AGH University Press in Geology, Geophysics and Environment
- Vol. 49 (2) , 197-202
Abstract
During the construction of a section of the S-7 Lubień – Rabka-Zdrój dual expressway, located in the area of the Carpathian flysch (Carpathian Flysch Belt, South Poland), damage to the embankment was observed, as well as cracks and depressions in the new pavement. An analysis of the geological and engineering conditions in the area of the road section under construction showed the existence of a complex tectonic structure of the flysch formations, a shallow groundwater table, and numerous landslides. In order to stabilize the road substrate, it was decided to carry out injections, and the locations of these injections were initially geotechnically tested. However, due to the high variability of the geological structure, the target method employed was electrical resistivity tomography (ERT), which performed the survey in two stages. In Stage I, the geoelectrical/geochemical structure of the near-surface zone was identified, and the probable causes of road damage were indicated. This stage was completed by performing the stabilization and sealing process of the ground with an injection mixture. In Stage II, studies were carried out to evaluate the effectiveness of the injection process. The ERT method effectively identified the shallow geological structure and, in particular, delineated the zone of strong fractures in the flysch and areas associated with faults. Using the electrical resistivity tomography method, it was also possible to determine the injection mixture’s approximate penetration depth and the loosening zone’s degree of filling.Keywords
This publication has 14 references indexed in Scilit:
- Application of electrical resistivity tomography (ERT) for rock mass quality evaluationScientific Reports, 2021
- The applicability of the Wenner method for resistivity measurement of concrete in atmospheric conditionsCase Studies in Construction Materials, 2021
- Geophysical and geotechnical approach to a landslide stability assessment: a case studyActa Geophysica, 2019
- ERT monitoring of gas injection into water saturated sands: Modelling and inversion of cross-hole laboratory dataJournal of Applied Geophysics, 2018
- Evaluation and localization of an artificial drainage network by 3D time-lapse electrical resistivity tomographyEnvironmental Science and Pollution Research, 2016
- Recent developments in the direct-current geoelectrical imaging methodJournal of Applied Geophysics, 2013
- The electrical resistivity tomography method in the detection of shallow mining cavities. A case study on the Victoria Cave, Cartagena (SE Spain)Engineering Geology, 2013
- Electrical resistivity survey in soil science: a reviewSoil and Tillage Research, 2005
- A comparison of smooth and blocky inversion methods in 2D electrical imaging surveysExploration Geophysics, 2003
- The development of DC resistivity imaging techniquesComputers & Geosciences, 2001