Abstract
A vertical inertial micropositioner for scanning probe microscopy was developed and tested. The special feature of the micropositioner is the employment of a rolling-balls guide for translation of a slider. The guide and a slider with a clamping mechanism are placed on the base of the micropositioner, and not on a piezoelement. The maximal unloading of the piezodrive allows us to keep its resonance frequencies high. This factor and the large force of the slider clamping permit us to apply a conventional sawtooth voltage for vertical motion. Such a micropositioner design makes it possible to simplify the driver electronics and to increase the mass of the translating part without significant reduction of the eigenfrequencies of the device. Step sizes from 22 to 1340 nm and speeds up to 0.7 mm/s are obtained. The micropositioner is capable of translating loads up to 25 g against gravity. Conditions for the use of the sawtooth wave form as an actuating voltage in the vertical inertial piezopositioner are also discussed.

This publication has 12 references indexed in Scilit: