A New Optimization Method for Centrifugal Compressors Based on 1D Calculations and Analyses
Open Access
Abstract
This paper presents an optimization design method for centrifugal compressors based on one-dimensional calculations and analyses. It consists of two parts: (1) centrifugal compressor geometry optimization based on one-dimensional calculations and (2) matching optimization of the vaned diffuser with an impeller based on the required throat area. A low pressure stage centrifugal compressor in a MW level gas turbine is optimized by this method. One-dimensional calculation results show that D3/D2 is too large in the original design, resulting in the low efficiency of the entire stage. Based on the one-dimensional optimization results, the geometry of the diffuser has been redesigned. The outlet diameter of the vaneless diffuser has been reduced, and the original single stage diffuser has been replaced by a tandem vaned diffuser. After optimization, the entire stage pressure ratio is increased by approximately 4%, and the efficiency is increased by approximately 2%.Keywords
This publication has 13 references indexed in Scilit:
- The Matching of a Vaned Diffuser With a Radial Compressor Impeller and Its Effect on the Stage PerformanceJournal of Turbomachinery, 2014
- Analysis and Validation of a Unified Slip Factor Model for Impellers at Design and Off-Design ConditionsJournal of Turbomachinery, 2011
- An optimum design procedure for an aerodynamic radial diffuser with incompressible flow at different Reynolds numbersProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2009
- Aerodynamic Shape Optimization of Turbine Blades Using a Design-Parameter-Based Shape Representation2007
- The Experimental Study of Matching Between Centrifugal Compressor Impeller and DiffuserJournal of Turbomachinery, 1999
- Laser Anemometer Measurements of the Flow Field in a 4:1 Pressure Ratio Centrifugal Impeller1997
- An optimum set of loss models for performance prediction of centrifugal compressorsProceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 1997
- Mean Streamline Aerodynamic Performance Analysis of Centrifugal CompressorsJournal of Turbomachinery, 1995
- A Review of Slip Factors for Centrifugal ImpellersJournal of Engineering for Power, 1967
- Losses in Vaneless Diffusers of Centrifugal Compressors and Pumps: Analysis, Experiment, and DesignJournal of Engineering for Power, 1966