Effect of Oil On the Boiling Performance of Structured and Porous Surfaces
Authors:
- Vlad ZarnescuVZVlad Zarnescu
- 1 January 2000
- journal article
- research article
- Published by Taylor & Francis in HVAC&R Research
- Vol. 6 (1) , 41-53
Abstract
The effect of geometric parameters and compressor oil concentration on the performance degradation of enhanced surfaces were investigated. Data are presented for innovative structured and porous surfaces. Refrigerant R-134a at 26.6°C with 1%, 2.5%, and 5% polyester-ester oil concentration by mass was used as the working fluid. Pore diameter was not found to be a major factor for the oil degradation of boiling performance on structured surfaces and that the smaller pore pitch yielded slightly greater oil degradation. Tubes with 50 fins/in (0.51 mm fin spacing) and 0.9 mm fin height had a smaller oil degradation than the Turbo-B surface. The rectangular fin base substantially enhanced the boiling performance in pure refrigerant but in the oil presence, this geometry performed poorly. The effect of oil degradation increased as the tunnel cross section area decreases. For 5% oil concentration, the porous surface had a performance degradation similar to the Turbo-B tube.Keywords
This publication has 10 references indexed in Scilit:
- A Parametric Study of Nucleate Boiling on Structured Surfaces, Part II: Effect of Pore Diameter and Pore PitchJournal of Heat Transfer, 1998
- A Parametric Study of Nucleate Boiling on Structured Surfaces, Part I: Effect of Tunnel DimensionsJournal of Heat Transfer, 1998
- A nucleate boiling model for structured enhanced surfacesInternational Journal of Heat and Mass Transfer, 1998
- Nucleate Pool Boiling Heat Transfer Coefficients of Distilled Water (H2O) and R-134a/Oil Mixtures From Rib-Roughened SurfacesJournal of Heat Transfer, 1997
- Boiling of new refrigerants: a state-of-the-art reviewInternational Journal of Refrigeration, 1996
- Convective Vaporization of Pure Refrigerants in Enhanced and Integral-Fin Tube BanksJournal of Enhanced Heat Transfer, 1994
- Nucleate pool boiling data for five refrigerants on plain, integral-fin and enhanced tube geometriesInternational Journal of Heat and Mass Transfer, 1992
- A Parametric Study of Boiling Heat Transfer in a Horizontal Tube BundleJournal of Heat Transfer, 1988
- Prediction of Nucleate Pool Boiling Heat Transfer Coefficients of Refrigerant-Oil MixturesJournal of Heat Transfer, 1984
- Nucleate Boiling Performance of Refrigerants and Refrigerant-Oil MixturesJournal of Heat Transfer, 1980