Corrected direct force balance method for atomic force microscopy lateral force calibration
Authors:
- 1 June 2009
- journal article
- conference paper
- Published by AIP Publishing in Review of Scientific Instruments
- Vol. 80 (6) , 066101
Abstract
This paper reports corrections and improvements of the previously reported direct force balance method (DFBM) developed for lateral calibration of atomic force microscopy. The DFBM method employs the lateral force signal obtained during a force-distance measurement on a sloped surface and relates this signal to the applied load and the slope of the surface to determine the lateral calibration factor. In the original publication [Rev. Sci. Instrum. 77, 043903 (2006)], the tip-substrate contact was assumed to be pinned at the point of contact, i.e., no slip along the slope. In control experiments, the tip was found to slide along the slope during force-distance curve measurement. This paper presents the correct force balance for lateral force calibration.Keywords
This publication has 13 references indexed in Scilit:
- Novel method for measuring nanofriction by atomic force microscopeJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2008
- Lateral force calibration of an atomic force microscope with a diamagnetic levitation spring systemReview of Scientific Instruments, 2006
- Direct force balance method for atomic force microscopy lateral force calibrationReview of Scientific Instruments, 2006
- Microelectromechanical device for lateral force calibration in the atomic force microscope: Lateral electrical nanobalanceJournal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena, 2005
- Normal and torsional spring constants of atomic force microscope cantileversReview of Scientific Instruments, 2004
- An improved wedge calibration method for lateral force in atomic force microscopyReview of Scientific Instruments, 2003
- Quantitative comparison of three calibration techniques for the lateral force microscopeReview of Scientific Instruments, 2001
- Tip friction — torsional spring constant determinationColloids and Surfaces B: Biointerfaces, 2000
- Calibration of rectangular atomic force microscope cantileversReview of Scientific Instruments, 1999
- Calibration of frictional forces in atomic force microscopyReview of Scientific Instruments, 1996