Thermoacoustic combustion instability of propane‐oxy‐combustion with CO2dilution: Experimental analysis
- 29 November 2019
- journal article
- research article
- Published by Hindawi Limited in International Journal of Energy Research
- Vol. 44 (2) , 1031-1045
Abstract
In this study, the effect of CO2 dilution on the thermoacoustic stability of propane‐oxyfuel flames is studied in a non‐premixed, swirl‐stabilized combustor. The results, obtained at a fixed combustor power density (4 MW/m3 bar) and global stoichiometric equivalence ratio (Φ = 1.0), show that the oxy‐flame is stable at 0% and low CO2 concentrations in the oxidizer. A self‐amplifying coupling between heat release and pressure fluctuations was observed to occur at the CO2 concentration of 45%, which matches the point of flame transition from a jet‐like to a V‐shaped flame resulting from the formation of inner recirculation zone. The observed frequency for both the pressure and heat release oscillations is 465 Hz and the ensuing thermoacoustic instability is believed to have been resulted from vortexes and flame interactions. Subsequent to the coupling of the oscillations at the CO2 concentration of 45%, their amplitudes grew at 50% to 60% CO2 dilution levels. The maximum amplitude was observed at 60% CO2 concentration after which, as CO2 dilution level increases, the acoustic amplitude and that of its counterpart in the heat release spectrum decreased due to damping (energy dissipation) arising from heat loss and viscous dissipation. An increase in hydrogen concentration in the fuel and a decrease in the combustor power density were observed to lower the acoustic amplitude. Furthermore, a frequency shift is observed with a change in the combustor firing rate, which shows that the mode scales with the flow velocity, and therefore, unlikely to be a natural acoustic mode of the combustor. This study, therefore, reveals thermoacoustic instability in non‐premixed oxy‐combustion driven by changes in flame dynamics and macrostructures as the CO2 concentration in the oxidizer mixture varies.Keywords
This publication has 52 references indexed in Scilit:
- Experimental Investigation of Thermoacoustic Instabilities for a Model Combustor With Varying Fuel ComponentsJournal of Engineering for Gas Turbines and Power, 2011
- Comparative Validation Study on Identification of Premixed Flame Transfer FunctionJournal of Engineering for Gas Turbines and Power, 2011
- Determination of the Heat Release Distribution in Turbulent Flames by a Model Based Correction of OH* ChemiluminescenceJournal of Engineering for Gas Turbines and Power, 2011
- Experimental analysis of the combustion behaviour of oxyfuel flames in a gas turbine model combustorProceedings of the Combustion Institute, 2011
- Gas turbine combustion performance test of hydrogen and carbon monoxide synthetic gasFuel, 2010
- On the Adequacy of Chemiluminescence as a Measure for Heat Release in Turbulent Flames With Mixture GradientsJournal of Engineering for Gas Turbines and Power, 2010
- Experimental characterization of onset of acoustic instability in a nonpremixed half-dump combustorThe Journal of the Acoustical Society of America, 2007
- Chemiluminescent OH* and CH* flame structure and aerodynamic scaling of weakly buoyant, nearly spherical diffusion flamesProceedings of the Combustion Institute, 2002
- Excitation of Thermoacoustic Instabilities by Interaction of Acoustics and Unstable Swirling FlowAIAA Journal, 2000
- Thermoacoustic oscillations in combustion chambers of gas turbinesAIAA Journal, 1995