Effects of Micro-Hole and Ultra-High Injection Pressure on Mixture Properties of D.I. Diesel Spray
Authors:
- 23 July 2007
- conference paper
- Published by SAE International in SAE International Journal of Advances and Current Practices in Mobility
- Vol. 1
Abstract
Experimental study has been carried out on the effects of the micro-hole nozzle injector and ultra-high injection pressure on the mixture properties of D.I. Diesel engine. A manually operated piston screw pump, High Pressure Generator, was used to obtain ultra-high injection pressures. Three kinds of injection pressures, 100MPa, 200MPa, and 300MPa, were applied to a specially designed injector. Four kinds of nozzle hole diameters, 0.16mm, 0.14mm, 0.10mm, and 0.08mm, were adopted in this study. The laser absorption-scattering (LAS) technique was used to analyze the equivalence ratio distributions, Sauter mean diameter, spray tip penetration length, and other spray characteristics. The analyses of the experimental results show that the micro-hole nozzle and ultra-high injection pressure are effective to increase the turbulent mixing rate and to form the uniform and lean fuel-air mixture. Consequently, the premixed compression-ignited (PCI) combustion can be achieved without advancing the injection timing greatly.Keywords
This publication has 23 references indexed in Scilit:
- Premixed Compression Ignition (PCI) Combustion for Simultaneous Reduction of NOx and Soot in Diesel EngineSAE International Journal of Advances and Current Practices in Mobility, 2004
- Non-Sooting, Low Flame Temperature Mixing-Controlled DI Diesel CombustionSAE International Journal of Advances and Current Practices in Mobility, 2004
- Effect of Small Holes and High Injection Pressures on Diesel Engine CombustionSAE International Journal of Advances and Current Practices in Mobility, 2002
- Quantitative Measurement of Droplets and Vapor Concentration Distributions in Diesel Sprays by Processing UV and Visible ImagesSAE International Journal of Advances and Current Practices in Mobility, 2001
- Engine Combustion Instrumentation and Diagnostics2001
- Imaging of droplets and vapor distributions in a Diesel fuel spray by means of a laser absorption–scattering techniqueApplied Optics, 2000
- Trial of New Concept Diesel Combustion System - Premixed Compression-Ignited Combustion -SAE International Journal of Advances and Current Practices in Mobility, 1999
- A New Concept for Low Emission Diesel Combustion (2nd Rep. : Reduction of HC and CO Emission, and Improvement of Fuel Consumption by EGR and MTBE Blended Fuel)SAE International Journal of Advances and Current Practices in Mobility, 1998
- Exhaust Purification of Diesel Engines by Homogeneous Charge with Compression Ignition Part 1: Experimental Investigation of Combustion and Exhaust Emission Behavior Under Pre-Mixed Homogeneous Charge Compression Ignition MethodSAE International Journal of Advances and Current Practices in Mobility, 1997
- Effects of Injection Pressure and Nozzle Geometry on Spray SMD and D.I. EmissionsSAE International Journal of Advances and Current Practices in Mobility, 1995