Influence of viscosity ratio on processing and morphology of thermotropic liquid crystal polymer‐reinforced poly(ethylene 2,6‐naphthalate) blends
Authors:
- 6 February 2006
- journal article
- research article
- Published by Wiley in Polymer International
- Vol. 55 (4) , 449-455
Abstract
Thermotropic liquid crystal polymer (TLCP) microfibril‐reinforced poly(ethylene 2,6‐naphthalate) (PEN) composites with various intrinsic viscosities were prepared by a melt compounding method. Polymer composites consisting of bulk cheap polyester with a small amount of expensive TLCP are of interest from a commercial perspective. The TLCP acts as a nucleating agent in the TLCP/PEN composites, enhancing the crystallization of the PEN matrix through heterogeneous nucleation. The structural viscosity index of the TLCP/PEN composites was lower than that of PEN and TLCP, which was attributed to the formation of TLCP fibrillar structures with elongated fibrils in the PEN matrix. The TLCP/PEN composites with higher intrinsic viscosity than the polymer matrix contained these elongated fibrils, and had a TLCP component with a smaller average diameter, and a narrower diameter distribution than TLCP/PEN composites with lower intrinsic viscosity. The higher intrinsic viscosity of the polymer matrix, the higher shear rate and the lower viscosity ratio of TLCP to PEN can all favour TLCP fibrillation in the polymer composites. Copyright © 2006 Society of Chemical IndustryKeywords
This publication has 37 references indexed in Scilit:
- Effects of electron beam irradiation on poly(ethylene 2,6‐naphthalate)/poly(ethylene terephthalate) blendsPolymer Engineering & Science, 2004
- Fiber property and structure development of polyester blend fibers reinforced with a thermotropic liquid‐crystal polymerJournal of Polymer Science Part B: Polymer Physics, 2003
- Miscibility study on blend of thermotropic liquid crystalline polymers and polyesterJournal of Applied Polymer Science, 2003
- Effects of shear rate, viscosity ratio and liquid crystalline polymer content on morphological and mechanical properties of polycarbonate and LCP blendsPolymer International, 2002
- Rheology and morphology of compatibilized polyamide 6 blends containing liquid crystalline copolyestersPolymer, 1998
- In situ composites based on blends of a poly(ether imide) and thermotropic liquid crystalline polymers under injection moulding conditionsPolymer, 1996
- Drop deformation in polymer blends during uniaxial elongational flowMacromolecular Symposia, 1995
- Chemical reactions between immiscible polymers in the melt: Transesterification of poly(ethylene‐co‐methyl acrylate) with mono‐hydroxylated polystyrenesJournal of Polymer Science Part A: Polymer Chemistry, 1995
- Compatibilizing effect of a poly(ester imide) on the properties of the blends of poly(ether imide) and a thermotropic liquid crystalline polymer: 1. Compatibilizer synthesis and thermal and rheological properties of the in situ composite systemPolymer, 1995
- Rheological properties of thermotropic liquid crystalline aromatic copolyestersPolymer Engineering & Science, 1988