Cr 3 C 2 –20%Ni cermets prepared by high energy milling and reactive sintering, and their mechanical properties
- 25 February 2016
- journal article
- research article
- Published by SAGE Publications in Advances in Applied Ceramics: Structural, Functional and Bioceramics
- Vol. 115 (6) , 327-332
Abstract
Cr3C2–20%Ni cermets were fabricated with Cr, C and Ni mixed-powder by high energy milling and reactive carburising sintering. The elemental powders of Cr, C and Ni were mixed with proper ratio (Cr/C = 3:2 atomic ratio) and milled to the nanometre crystallite sizes (about 20–30 nm). Specimens were cold-isostatically pressed at 200 MPa and sintered at 1453, 1503 and 1553 K with vacuum atmosphere for 1 h, respectively. It was shown that the relative density of the sintered specimens increases first and then decreases slightly with increasing sintering temperature. The maximum values of the hardness (86.7HRA) and bending strength (1140 MPa) were achieved at 1503 K.Keywords
Funding Information
- The 863 project in China (No. 2013AA031203)
- The Special Funds for Strategic Emerging Industries Core Technology Research of Guangdong Province in China (No. 2012A090100018)
This publication has 15 references indexed in Scilit:
- Effects of milling and subsequent consolidation treatment on the microstructural properties and hardness of the nanocrystalline chromium carbide powdersInternational Journal of Refractory Metals and Hard Materials, 2012
- Synthesis of chromium carbide (Cr3C2) nanopowders by the carbonization of the precursorInternational Journal of Refractory Metals and Hard Materials, 2011
- Phase evolution, microstructure characteristics and properties of Cr3C2-Ni cermets prepared by reactive sinteringInternational Journal of Materials and Product Technology, 2011
- Microstructural characterization of nanocrystalline chromium carbides synthesized by high energy ball millingJournal of Alloys and Compounds, 2010
- Effect of fabrication methods on microstructure and mechanical properties of Fe3Al-based alloysJournal of Alloys and Compounds, 2009
- Erosion and abrasion of chromium carbide based cermets produced by different methodsWear, 2007
- Microstructural and Mechanical Characteristics of in Situ Synthesized Chromium-Nickel-Graphite CompositesMaterials Science Forum, 2007
- Tribological performance of chromium/chromium carbide multilayers deposited by r.f. magnetron sputteringSurface and Coatings Technology, 2005
- Effects of deposition parameters on the properties of chromium carbide coatings deposited onto steel by sputteringMaterials Science and Engineering: A, 2002
- Liquid-phase sintering and properties of Cr3C2/NiCr cermetsJournal of Materials Processing Technology, 1998