Creep behavior of polymeric adhesive joints exposed to different environmental conditions
- 22 April 2020
- journal article
- research article
- Published by Wiley in Polymer Composites
- Vol. 41 (8) , 3218-3226
Abstract
This article intends to examine the creep response of single‐lap adhesive joints (SLAJs) exposed to different environmental and temperature conditions. Therefore, SLAJs were fabricated and then immersed in seawater and deionized water at 40°C for 24 hours before conducting creep tests. The experimental results showed that seawater had lower detrimental effect on the creep and elastic responses of SLAJs than deionized water. The shear creep and elastic strain values of SLAJs immersed in deionized water increased averagely by 19.8% and 43%, respectively, whereas those strains for SLAJs immersed in seawater increased averagely by 2.1% and 28.8%, respectively, compared to SLAJs maintained in dry condition. This was because of the higher moisture ingress of adhesives aged in deionized water than in seawater due to the osmosis phenomenon. Moreover, the results showed 23% and 14% increase in shear creep and elastic strains, respectively, by increasing the water temperature from 30°C to 50°C. Furthermore, the time‐dependent responses of SLAJs immersed in different environments with different ageing temperatures were simulated by Burgers rheological model.Keywords
This publication has 26 references indexed in Scilit:
- Investigation of the long term effects of moisture on carbon fibre and epoxy matrix compositesComposites Science and Technology, 2012
- Limiting shear creep of epoxy adhesive at the FRP–concrete interface using multi-walled carbon nanotubesInternational Journal of Adhesion and Adhesives, 2012
- Modelling the effect of moisture on the depth sensing indentation response of a stereolithography polymerComputational Materials Science, 2012
- Influence of water on the nanoindentation creep response of nylon 6Journal of Applied Polymer Science, 2007
- Analysis of the creep behavior of polypropylene‐woodflour compositesPolymer Engineering & Science, 2004
- Creep and recovery behavior of novel organic‐inorganic polymer hybridsPolymer Composites, 2002
- Sea Water Aging of Glass Reinforced Composites: Shear Behaviour and Damage ModellingJournal of Composite Materials, 2001
- Creep behavior of nylon‐6 thermoplastic compositesPolymer Composites, 1997
- The Effects of Molecular Weight on the Single Lap Shear Creep and Constant Strain Rate Behavior of Thermoplastic Polyimidesulfone AdhesiveThe Journal of Adhesion, 1986
- The Creep Behaviour of Structural Adhesive Joints-IThe Journal of Adhesion, 1975