Effects of Experimental Parameters on Condensation Heat Transfer in Plate Fin Heat Exchanger
Open Access
Abstract
This study aims to provide an experimental investigation and comparison of the condensation heat transfer characteristics in a plate–fin heat exchanger (PFHE). The heat flux, mass flux, and saturation pressure were adjusted as experimental parameters to verify the effects on the condensation heat transfer. In addition, condensation heat transfer correlation of two-stream PFHEs was provided based on the experimental data for utilization as a design reference for the heat exchanger. The turbulence is the most influential in heat transfer. One of the ways to foster turbulence is to increase shear stress. The higher flow velocity results in the higher shear stress. That was why increasing mass flux or the flow with higher vapor quality showed the higher heat transfer coefficient (HTC). Refrigerant properties such as viscosity and specific volume of vapor changed according to the saturation pressure. It is expected they affect the degree of turbulence too in similar manners. The mass flux was more influential than the heat flux and saturation pressure. Thus, the equivalent mass flux of the refrigerant is dominant in the derived correlation model. The average difference between experimental and calculated HTC from correlations was about 6.5%. Multi-stream PFHE comprises an additional heat transfer surface, which implies a more active droplet formation. The average pressure drop in the multi-stream is 15% larger than that of the two-stream.Keywords
Funding Information
- Ministry of Land, Infrastructure and Transport (21IHTP-B151609-03)
This publication has 34 references indexed in Scilit:
- Heat transfer during the condensation of R134a inside eight parallel microchannelsInternational Journal of Heat and Mass Transfer, 2013
- Laboratory Practices with the Wilson Plot MethodExperimental Heat Transfer, 2007
- Experimental apparatus for measuring heat transfer coefficients by the Wilson plot methodEuropean Journal of Physics, 2005
- Design Methodology for Multistream Plate-Fin Heat Exchangers in Heat Exchanger NetworksHeat Transfer Engineering, 2001
- Surface selection and design of plate–fin heat exchangersApplied Thermal Engineering, 1999
- Condensation heat transfer and pressure drop of refrigerant R-134a in a plate heat exchangerInternational Journal of Heat and Mass Transfer, 1999
- Fin efficiency and mechanisms of heat exchange through fins in multi-stream plate-fin heat exchangers: development and application of a rating algorithmInternational Journal of Heat and Mass Transfer, 1997
- Condensation of R-12 in small hydraulic diameter extruded aluminum tubes with and without micro-finsInternational Journal of Heat and Mass Transfer, 1996
- Fin efficiency and mechanisms of heat exchange through fins in multi-stream plate-fin heat exchangers: formulationInternational Journal of Heat and Mass Transfer, 1996
- A General Heat Transfer Correlation for Annular Flow CondensationJournal of Heat Transfer, 1968