Lead Zirconate‐Lead Titanate Piezoelectric Ceramics with Iron Oxide Additions
Authors:
- 1 May 1969
- journal article
- Published by Wiley in Journal of the American Ceramic Society
- Vol. 52 (5) , 253-257
Abstract
An investigation of the effects of small additions of Fe2O3 to lead zirconate‐lead titanate ceramics with compositions between 45 and 60 mol% lead zirconate has shown that, with 2 moles of PbO to balance each mole of Fe2O3, the solubility of Fe2O3 was about 0.8 wt% in compositions near the tetragonal‐rhombohedra1 boundary. The dielectric constant and dissipation factor for both rhombohedra1 and tetragonal materials were decreased by addition of iron oxide, whereas the mechanical quality factor and frequency constant were increased. The dependence of the electromechanical properties on grain size was qualitatively similar for both undoped and iron oxide‐doped materials; the presence of iron oxide inhibited grain growth and lowered the limiting grain size below which the electromechanical properties change rapidly with grain size.Keywords
This publication has 7 references indexed in Scilit:
- Preparation and properties of the SrTi1−xFexO3−x2/Ox2 systemMaterials Research Bulletin, 1968
- Variations in properties with composition in lead zirconate-titanate ceramics1967
- The effects of some variations in fabrication procedure on the properties of lead zirconate-titanate ceramics made from spraydried, co-precipitated powders1967
- Temperature and Bias Characteristics of Pb(Zr-Ti)O3 Families CeramicsJapanese Journal of Applied Physics, 1965
- Effect of Fe 4+ in the System SrFeO 3 ‐SrTiO 3Journal of the American Ceramic Society, 1963
- Electromechanical Properties of Lead Titanate Zirconate Ceramics with Lead Partially Replaced by Calcium or StrontiumJournal of the American Ceramic Society, 1959
- Measurement of Particle Sizes in Opaque BodiesJOM, 1953