Recovery of indium from the etching solution of indium tin oxide by solvent extraction
Authors:
Open Access
- 18 January 2016
- journal article
- research article
- Published by Wiley in Environmental Progress & Sustainable Energy
- Vol. 35 (3) , 758-763
Abstract
The etching waste solution from the indium‐consuming fabrication processes is considered as the viable resource for indium recovery. The extraction equilibrium of indium(III) from a hydrochloride acid solution using di‐(2‐ethylhexyl) phosphoric acid (D2EHPA) as an extractant and dissolved in kerosene by solvent extraction was studied. To optimize the extraction and separation of indium from etching waste solution, the effects of O/A ratio, pH, and extractant concentration on the distribution ratios of In(III) and selective precipitation of alumina, cerium, and iron from indium were also investigated in this work. The experimental results showed that satisfactory separation of alumina, cerium, and iron from indium was achieved with 0.3 M D2EHPA at room temperature and pH values ranging from 1 to 1.5. In this process, 92% of indium could be extracted from 0.74 to 8.62 g/L at an O/A ratio of 1:1. Quantitative stripping experiments of indium by HCl showed that the preferred O/A phase ratio was 1:2 or less at HCl concentration of 2.0 M to attain a high indium recovery and minimum iron coextraction. Where maximum purity is desired, the extraction is desirably carried out in three theoretical extraction stages. Based on these results, the aqueous and organic phase parameters can be easily manipulated to attain a high separation efficiency of indium(III) from commonly associated elements. © 2016 American Institute of Chemical Engineers Environ Prog, 35: 758–763, 2016Keywords
Funding Information
- Department of Economic Affairs (100-EC-17-A-11-02-0706)
This publication has 19 references indexed in Scilit:
- Extraction Equilibrium of Indium(III) from Nitric Acid Solutions by Di(2-ethylhexyl)phosphoric Acid Dissolved in KeroseneMolecules, 2012
- Recovery of indium from etching waste by solvent extraction and electrolytic refiningHydrometallurgy, 2011
- Recovery of indium from used indium–tin oxide (ITO) targetsHydrometallurgy, 2011
- Pyrometallurgical Recovery of Indium from Dental Metal Recycling Sludge by Chlorination Treatment with Ammonium ChlorideMATERIALS TRANSACTIONS, 2010
- Recovery of indium from etching wastewater using supercritical carbon dioxide extractionJournal of Hazardous Materials, 2009
- Recovering Indium from the Liquid Crystal Display of Discarded Cellular Phones by Means of Chloride-Induced Vaporization at Relatively Low TemperatureMetallurgical and Materials Transactions A, 2009
- Separation and preconcentration of trace indium(III) from environmental samples with nanometer-size titanium dioxideHydrometallurgy, 2009
- Extraction of indium from indium-zinc concentratesTransactions of Nonferrous Metals Society of China, 2006
- Extraction and separation of In(III), Ga(III) and Zn(II) from sulfate solution using extraction resinHydrometallurgy, 2006
- Solvent extraction of indium (III) by LIX 973NHydrometallurgy, 1999